Near-Field to Far-Field Transformation for an Outdoor RCS Range
スポンサーリンク
概要
- 論文の詳細を見る
This paper presents the near-field to far-field transformation for an outdoor radar cross section (RCS) range. Direct measurement of the large actual target requires quite a long measurement range. The near-field to far-field RCS transformation method achieves the reduction of measurement range. However the non-uniformity of the incident electric field distribution on the target causes some errors in RCS prediction. We propose a novel near-field to far-field RCS transformation method that can be applied to an outdoor RCS measurement. The non-uniformity of the incident electric field distribution is successfully resolved by introducing the correction term of the ground bounce. We investigate the validity of the proposed method by the simulation and measurement.
- （社）電子情報通信学会の論文
- 2008-09-01
著者
-
Makino Shigeru
Department Of Information And Communication Engineering Kanazawa Institute Of Technology
-
Makino S
Department Of Information And Communication Engineering Kanazawa Institute Of Technology
-
Kuroda Shinji
Information Technology R&d Center Mitsubishi Electric Corporation
-
INASAWA Yoshio
Information Technology R&D Center, Mitsubishi Electric Corporation
-
Inasawa Yoshio
Information Technology R&d Center Mitsubishi Electric Corporation
-
KAKIZAKI Ken-ichi
Kamakura Works, Mitsubishi Electric Corporation
-
NISHIKAWA Hitoshi
Kamakura Works, Mitsubishi Electric Corporation
-
YONEDA Naofumi
Information Technology R&D Center, Mitsubishi Electric Corporation
-
Nishikawa Hitoshi
Kamakura Works Mitsubishi Electric Corporation
-
Kakizaki Ken-ichi
Kamakura Works Mitsubishi Electric Corporation
-
Yoneda Naofumi
Information Technology R&d Center Mitsubishi Electric Corporation
-
Inasawa Yoshio
Information Technology R&D Center, Mitsubishi Electric Corporation
関連論文
- Pattern Analysis of a GPS Microstrip Antenna on a Rectangular Ground Plane by Using Modified Edge Representation
- Equivalent Edge Currents for Modified Edge Representation of Flat Plates: Fringe Wave Components
- Using Conducting Wire at A-Sandwich Junctions to Improve the Transmission Performance of Radomes
- RCS Prediction Method from One-Dimensional Intensity Data in Near-Field
- Near-Field to Far-Field Transformation for an Outdoor RCS Range
- Design Method for a Low-Profile Dual-Shaped Reflector Antenna with an Elliptical Aperture by the Suppression of Undesired Scattering
- Radar Cross Section Analysis Considering Multi-Reflection inside a Radome Based on SBR Method(Imaging, Wireless Technologies and Computational Electromagnetics)
- AN OMNI-DIRECTIONAL HORN-REFLECTOR TYPE SHAPED REFLECTOR 6-SECTOR ANTENNA FOR BASE STATION APPLICATION IN P-MP FIXED WIRELESS ACCESS SYSTEMS
- Far-Field RCS Prediction Method Using Cylindrical or Planar Near-Field RCS Data
- A Waveguide-Based Power Divider Using H-Plane Probes Short-Circuited with Substrate Metallization Patterns
- A Millimeter-Wave Resistance Error Tolerant Termination in Multi-Layered LTCC Substrate
- One-Dimensional Electronic Beam-Scanning Center-Fed Imaging Reflector Antenna