Flow Visualization and Numerical Simulation of T-Junction Mixing of High-Temperature High-Pressure Water
スポンサーリンク
概要
- 論文の詳細を見る
Fluid flow at the T-junction of a model of a supercritical water microreactor is studied experimentally and numerically. Experimental cells are fabricated from three pieces of sapphire; the flow path width is 2 mm while the depth is 2.5 mm. SC/Tetra is used as the computational fluid dynamics software and three-dimensional calculation is performed. Experimental results and numerical results are compared for the condition where the temperature and pressure of hot water are 389 K and 45 MPa, respectively. Natural convection is found to be dominant even in such a small flow area.
- 社団法人 化学工学会の論文
- 2009-03-01
著者
-
Suzuki Akira
Research Center for Compact Chemical System, National Institute of Advanced Industrial Science and T
-
Aizawa Takafumi
Research Center For Compact Chemical Process National Institute Of Advanced Industrial Science And T
-
Masuda Yoshio
Research Center For Compact Chemical Process National Institute Of Advanced Industrial Science And T
-
Masuda Yoshio
Research Center For Compact Chemical Process National Institute Of Advanced Industrial Science And T
-
Suzuki Akira
Research Center For Compact Chemical Process National Institute Of Advanced Industrial Science And T
-
Suzuki Akira
Research And Development Group Engineering Div.
関連論文
- Development of Novel Micro Swirl Mixer for Producing Fine Metal Oxide Nanoparticles by Continuous Supercritical Hydrothermal Method
- Synthesis and characterization of hollow silica sphere with porous architecture in CO_2/H_2O interface
- Depolymerization of Poly(ethylene terephthalate) to Terephthalic Acid and Ethylene Glycol in High-temperature Liquid Water
- Particle-size Effects of Activated Carbon-supported Rhodium Catalysts on Hydrogenation of Naphthalene in Supercritical Carbon Dioxide Solvent
- Anti-conidial Germination Factors Induced in the Presence of Probenazole in Infected Host Leaves. II. Structural Elucidation of the Major Component (Substance B)
- A New Micromixer with Needle Adjustment for Instant Mixing and Heating under High Pressure and High Temperature
- Non-Woven Fabrics as New Cell Matrices for IMR-90 Human Embryonic Lung Diploid Fibroblast Cells
- Chemical Recycling Process of Poly(Ethylene Terephthalate) in High-Temperature Liquid Water
- Continuous Toluene Hydrogenation System Using Compressed Carbon Dioxide
- Development of a New Commercial-Scale Airlift Fermentor for Rapid Growth of Yeast
- Estimation of Local Density Augmentation and Hydrogen Bonding between Pyridazine and Water under Sub- and Supercritical Conditions Using UV-Vis Spectroscopy
- Polarity Determination of InN by Atomic Hydrogen Irradiation
- Numerical Investigation of Joule-Heating Microtube Heater for Supercritical State Water Generation : Heat Transfer Characteristics of Single Microtube
- Performance Evaluation of a High Pressure Microtube as a High-Speed Heating Device for Supercritical State Generation
- Flow Visualization and Numerical Simulation of T-Junction Mixing of High-Temperature High-Pressure Water
- A Facile and Continuous Fabrication of Polyimide Hollow Nanoparticles Using a Microfluidic System
- Continuous Fabrication of Novel Polyimide Nanoparticles Confining Highly Dispersed Gold Nanoparticles by a Multistep Microfluidic Reaction System and Their Catalytic Application
- Effects of Exposure to Nanoparticle-Rich Diesel Exhaust on Pregnancy in Rats
- Continuous Dehydrogenation of Aqueous Formic Acid under Sub-Critical Conditions by Use of Hollow Tubular Reactor Coated with Thin Palladium Oxide Layer
- Anti-conidial Germination Factors Induced in the Presence of Probenazole in Infected Host Leaves. III. Structural Elucidation of Substances A and C
- Effects of Exposure to Nanoparticle-rich Diesel Exhaust on Pregnancy in Rats