Effects of Particle Size on Mechanical Properties of a TiC Containing Tool Steel by Hot Isostatic Press
スポンサーリンク
概要
- 論文の詳細を見る
- Japan Institute of Metalsの論文
- 2008-03-01
著者
-
Chang Shih-hsien
Department Of Materials And Mineral Resources Engineering National Taipei University Of Technology
-
Chang Shih-hsien
Assab Steel Taiwan
-
TANG Tzu-Piao
Department of Materials and Mineral Resources Engineering, National Taipei University of Technology
-
CHEN Jhewn-Kuang
Department of Materials and Mineral Resources Engineering, National Taipei University of Technology
-
CHAN Sen-Fu
Department of Materials and Mineral Resources Engineering, National Taipei University of Technology
-
Chan Sen-fu
Department Of Materials And Mineral Resources Engineering National Taipei University Of Technology
-
Tang Tzu-piao
Department Of Materials And Mineral Resources Engineering National Taipei University Of Technology
-
Tang Tzu-piao
Dep. Of Materials And Mineral Resources Engineering National Taipei Univ. Of Technol.
-
Chen Jhewn-kuang
Department Of Materials And Mineral Resources Engineering National Taipei University Of Technology
-
Chen Jhewn-kuang
National Taipei Univ. Of Technol. Inst. Of Materials Sci. And Engineering
関連論文
- Influences of γ" and δ Precipitations on the Microstructural Properties of 718 Alloy through HIP, Solid-Solution, and Different Aging Heat Treatments
- Optimization of Pressure and Soaking Time of HIP Treatment on 713LC Cast Superalloy
- The Influence of Canning HIP Treatment on the Microstructure Characters of Cr35-Si65 and Cr50-Si50 Targets
- Effects of HIP Treatment on the Microstructure and Properties of Cr35-Si65 Target
- Effect of Shot Peening Treatment on Forging Die Life
- Effects of Particle Size on Mechanical Properties of a TiC Containing Tool Steel by Hot Isostatic Press
- Effects of HIP Treatment on the Microstructure of Cr50-Si50 Target
- Improvement in the Microstructure and Tensile Properties of Inconel 718 Superalloy by HIP Treatment
- Influences of Soaking Time in Hot Isostatic Pressing on Strength of Inconel 718 Superalloy
- Microstructure and Mechanical Properties of 440C-TiC Composite Steels Produced through Powder Metallurgy Processing
- Improvement of Aluminum Erosion Behavior and Corrosion Resistance of AISI H13 Tool Steel by Oxidation Treatment
- Enhancement of Erosion Resistance on AISI H13 Tool Steel by Oxynitriding Treatment
- Effects of γ' Precipitation on the Structure and Properties of 713LC Superalloy via HIP Treatment
- Effects of Thermal Erosion and Wear Resistance on AISI H13 Tool Steel by Various Surface Treatments
- Formation of Al and Cr Dual Coatings by Pack Cementation on SNCM439 Steel
- Effects of Post-oxidizing Treatment on Melting Loss and Corrosion Resistance of Gas Nitrided AISI H13 Tool Steel
- Sintered Behaviors and Electrical Properties of Cr50Cu50 Alloy Targets via Vacuum Sintering and HIP Treatments
- Effects of Zinc Oxide and Porosity on Permittivity of Sintered Zinc Sulfide–Silicon Dioxide
- Improvement of Mechanical and Electrical Properties on the Sintered Ni-50 mass% Cr Alloys by HIP Treatment