Understanding Dry-WEDM Phenomena through Periodic Oscillation of Discharge Gap
スポンサーリンク
概要
- 論文の詳細を見る
- 2005-01-01
著者
-
KUNIEDA Masanori
Tokyo Univ. of Agri. & Tech.
-
Kunieda Masanori
Tokyo University Of Agriculture & Technology
-
FURUDATE Chika
Tokyo Univ. of Agri. & Tech.
-
Furudate Chika
Tokyo University Of Agriculture & Technology
関連論文
- Improvement of acuracy in potential method for detecting EDM spark locations
- Fundamental Study on Quantitative Estimation of Discharge Delay Time in EDM
- Contouring of polished single-crystal silicon plates by wire electrical discharge machining
- Influence of Electrode Surface Profile on Discharge Delay Time in Electrical Discharge Machining
- Feasibility of 3-D Surface Machining by Dry EDM
- Electrical Discharge Machining Using Electrically Conductive CVD Diamond as an Electrode (第180回電気加工研究会)
- Simultaneous Processing Method for Micro-Rods and Holes Using EDM
- Simulation of Electrode Surface Temperature in Die-Sinking EDM Process
- Research on anisotropy in electrical discharge machining of monocrystalline silicon
- Difference in limit of miniaturization between monocrystalline and polycrystalline aluminum in EDM
- Study on Influence of Inter-electrode Atmosphere on Carbon Adhesion and Removal Amount
- Relation between Debris Concentration and Discharge Gap Width in EDM Process
- Relation Between Debris Concentration and Discharge Gap Lenght in EDM Process
- Study on the Dry WEDMed Surface Layer
- Understanding Dry-WEDM Phenomena through Periodic Oscillation of Discharge Gap