アークイオンプレーティング法により形成したCr-Si-N皮膜の機械的特性およびバイアス電圧の影響
スポンサーリンク
概要
- 論文の詳細を見る
Cr-Si-N coatings were prepared by incorporating several atomic percentage of Si to CrN, using an arc ion plating method. In order to change the Si content in the coatings, CrSi targets of 5, 10, 15at%Si were used. The bias voltages were changed from 0 to −250V. Silicon wafers and carburized Chromium Molybdenum Steels (SCM415) were used as the substrates. The aim of this study is to investigate the influence of Si incorporation and bias voltage on the structure and mechanical properties of the coatings. The hardness of the coatings increased drastically up to Hk4000 at 3at%Si with only a very small quantity of Si incorporated. The hardness was also influenced strongly by the bias voltage and increased with increasing bias voltage, attaining maximum at around −60V and then decreased with increasing bias voltage. This can be explained by the change of internal stress of the coatings. The adhesion of the Cr-Si-N coatings was a little smaller than that of the CrN coatings, but within a lower bias voltage range of 0˜−30V. The critical load on scratch test was 60N, the same as that of the CrN coating. The X-ray diffraction (XRD) profiles showed that the coatings with a low content of Si incorporated to CrN presented a polycrystalline structure consisting of nano-crystalline CrN which seemed to be separated from each other by an amorphous Si-N(a-Si-N) phase. It was assumed that the high hardness of the CrSiN coatings was mainly attributed to the formation of a composite structure of nc-CrN and a-Si-N and the decrease of the CrN grain size.
- 一般社団法人 表面技術協会の論文
- 2004-04-01
著者
関連論文
- クロムをイオン注入したType304 ステンレス鋼の腐食挙動
- イオンプレーティング法により形成したTi-Si-Nナノ複合皮膜の硬さと微細組織
- アークイオンプレーティング法により形成したCr-Si-N皮膜の機械的特性およびバイアス電圧の影響
- 化学緻密化法によるセラミックコ-ティング (ファインセラミックスの最近の動向) -- (セラミックス利用技術)
- W-CDMA無線基地局における高密度実装技術 (特集 次世代移動通信(IMT-2000))