Skill Training of Manual Machine Operation by Simulator - In the Case of Small-Diameter Deep-Hole Machining with Drilling Machine -

スポンサーリンク

概要

• 論文の詳細を見る
• 1998-03-31

著者

• Kato H

  Chiba University

• KATO Hideo

  Faculty of Engineering Chiba University

• CHEN Wen

  Graduate School of Science and Technology, Chiba University

• Chen W

  Center For Environmental Remote Sensing Chiba University

関連論文

• Computer Aided Inspection of Drill Point Geometry (2nd Report) - A Simple Inspection Method by Using CCD Camera -
• Computer Aided Inspection of Drill Point Geometry-Error Analysis of Simple Inspection Method Using CCD Camera-
• Entry of the New Quinolone Antibacterial Agents of Ofloxacin and NY-198 into the Central Nervous System in Rats
• Drilling Machine Simulator Considering Deflection of Drill
• Effects of Platinum Diffusion on MOS System
• Improvement of In-Situ Circularity Measurement Technique Based on Three-Point Method and Development of n-Point Method
• Skill Training of Manual Machine Operation by Simulator - In the Case of Small-Diameter Deep-Hole Machining with Drilling Machine -
• Effect of Auditory Feedback on Operating Efficiency and Fatigue -In the Case of Manual Cut-Off Turning with Virtual Lathe-
• Active Sensory Feedback in Manual Machine Tool Operation - Effect of Auditory and Force Sensory Feedback of Cutting Force in Fine Machining -
• Skill Learning in Manual Machine Tool Operation - Development of New Virtual Lathe and Study on Minute Grooving by Using It -

スポンサーリンク