Improvement of In-Situ Circularity Measurement Technique Based on Three-Point Method and Development of n-Point Method
スポンサーリンク
概要
- 論文の詳細を見る
- 1995-03-31
著者
-
Kato H
Chiba University
-
KATO Hideo
Faculty of Engineering Chiba University
-
KATO Hideo
Chiba University
-
Kato H
Chiba Univ. Chiba‐shi
-
NOMURA Yujiro
Seiko Epson Co.
-
NAKANO Yoshikuni
Shonan Institute of Technology
関連論文
- Computer Aided Inspection of Drill Point Geometry (2nd Report) - A Simple Inspection Method by Using CCD Camera -
- Computer Aided Inspection of Drill Point Geometry-Error Analysis of Simple Inspection Method Using CCD Camera-
- Entry of the New Quinolone Antibacterial Agents of Ofloxacin and NY-198 into the Central Nervous System in Rats
- Drilling Machine Simulator Considering Deflection of Drill
- Effects of Platinum Diffusion on MOS System
- Improvement of In-Situ Circularity Measurement Technique Based on Three-Point Method and Development of n-Point Method
- Skill Training of Manual Machine Operation by Simulator - In the Case of Small-Diameter Deep-Hole Machining with Drilling Machine -
- Effect of Auditory Feedback on Operating Efficiency and Fatigue -In the Case of Manual Cut-Off Turning with Virtual Lathe-
- Active Sensory Feedback in Manual Machine Tool Operation - Effect of Auditory and Force Sensory Feedback of Cutting Force in Fine Machining -
- Skill Learning in Manual Machine Tool Operation - Development of New Virtual Lathe and Study on Minute Grooving by Using It -