スポンサーリンク
Department Of Materials Science And Engineering Yonsei University | 論文
- A Phenomenological Investigation on the Control of Oxides at the Interface Using an Electrochemical Cell
- Effects of Si on Microstructural Evolution and Mechanical Properties of Hot-rolled Ferrite and Bainite Dual-phase Steels
- Dynamic Strain-Induced Ferrite Transformation during Hot Compression of Low Carbon Si-Mn Steels
- Synthesis of Ni-Based Bulk Metallic Glasses for Penetrating Materials
- Effect of the Acceleration Energy of Hydrogen Ion Irradiation on Perpendicular Magnetic Anisotropy in CoO_x/Pd Multilayer Films
- Effect of Copper Addition on the Active Corrosion Behavior of Hyper Duplex Stainless Steels in Sulfuric Acid
- Influence of TiO_2 on the Viscous Behavior of Calcium Silicate Melts Containing 17 mass% Al_2O_3 and 10 mass% MgO
- Influence of Li_2O on the Viscous Behavior of CaO-Al_2O_3-12 mass% Na_2O-12 mass% CaF_2 Based Slags
- Upconversion Emission in Er and Cr Co-Doped KNbO3 Phosphors
- Effects of Sulfur Addition on the Formation of Inclusions and the Corrosion Behavior of Super Duplex Stainless Steels in Chloride Solutions of Different pH
- Photochromic Effect in Stoichiometric LiNbO3:Fe,Mn
- Nanograting Fabrication on the Surface of Silicon and Gallium Arsenide Using Femtosecond Laser Pulses
- Dependence of Processing Parameters on Structural Properties and Microstructures of Pulsed Laser Deposited LiMn2O4 Thin Films
- Comparative Studies of Atomic Layer Deposition and Plasma-Enhanced Atomic Layer Deposition Ta2O5 and the Effects on Electrical Properties of In situ Nitridation
- Effect of NaF and CaO/SiO2 on the Hydrogen Dissolution in the CaO–SiO2–FeOt Based Flux System
- Morphologies of Alumina Nano- and Microparticles at the Fe/Al2O3 Interface and the Effects of Reaction Time and Substrate Roughness on Size Distribution
- A Kinetic Study on Carburization of Fe by Using 13CO Isotope Gas
- Mechanism of Localized Corrosion and Phase Transformation of Tube-to-Tube Sheet Welds of Hyper Duplex Stainless Steel in Acidified Chloride Environments
- Microstructural Evolution during Austenitization and Quenching of a 5% Cr Work Roll