Velocity Measurement Behind a Circular Cylinder Placed Horizontally in Bubbling Jet
スポンサーリンク
概要
- 論文の詳細を見る
- 日本混相流学会の論文
- 2003-03-15
著者
-
Iguchi Manabu
Hokkaido Univ. Sapporo Jpn
-
Iguchi Manabu
Hokkaido Univ. Hokkaido Jpn
-
Iguchi M
Hokkaido University
-
Yamashita Tomoya
Department Of Materials Engineering Hokkaido University
-
MIZUNO Yoshiteru
Hokkaido University
-
Mizuno Y
Hokkaido University
関連論文
- Physical-modeling Study of Fluid Flow and Gas Penetration in a Side-blown AOD Converter
- Frequency of Bubble Formation from a Multi-Hole Nozzle Attached to a Top Lance
- Bubble Formation from a Two-Hole Nozzle Attached to a Top Lance
- Bubble Formation Frequency at a Single-hole Nozzle Immersed in a Mercury Bath
- Merging Distance of Two Air-Water Vertical Bubbling Jets Subjected to coanda Effect
- Coanda Effect on Bubble Characteristics in a Bubbling Jet Rising Near the Side Wall of a Cylindrical Vessel
- Transition to Turbulence in Constant Velocity Pipe Flow after Initial Constant-Acceleration
- Flow Establishment Time of a Water Bath Contained in a Cylindrical Vessel Set in Sudden Rotation
- Model Study of Fluid Flow Phenomena in a Bottom Blown Bath in the Presence of Reverse Emulsification
- Study of Noise Reduction in Cross Flow Fans with Annular Bands
- Effects of the Physical Properties of Top Oil Layer on Bubble and Liquid Flow Characteristics in a Bottom Blown Water Bath
- Numerical Analysis of Transient Flow in a Water Bath Contained in a Cylindrical Vessel Suddenly Set in Rotation
- Tailoring and Measurements of Unsteady Pipe Flow
- Critical Reynolds Number in Constant-Acceleration Square Duct Flow
- Flow Rate Measurement in Unsteady Pipe Flow through a Plate Orifice
- Prevention of Air Suction from the Contact-part between Sliding Gate and Immersion Nozzle
- Removal of Inclusion through Bubble Curtain Created by Swirl Motion in Submerged Entry Nozzle
- Swirling Effect in Immersion Nozzle on Flow and Heat Transport in Billet Continuous Casting Mold
- Mixing Time in a Side-Blown Converter
- Development of a Method of Nitrate Nitrogen Treatment using Catalyst Particles and Reaction Gas
- Physical Modeling of a Sampler Filling for Molten Steel
- The Coordination of F Ions around Mg and Ca Ions in Molten CaO–CaF2–MgO–SiO2 System at 1873K
- Self-Induced Rotary Sloshing Caused by an Upward Off-Centered Jet in a Cylindrical Container
- Swirl Motion of a Mercury Jet Appearing in a Cylindrical Vessel in Transient Period
- Particle Layer Thickness Effect on Particle Entrainment in a Mechanically Agitated Bath
- Swirl motion of a water jet in a water bath of linearly increasing depth (特集 流動の可視化)
- EFFECT OF LOW-DENSITY PARTICLES ON SWIRLING LIQUID JET IN TRANSIENT PERIOD
- Water-model Experiment on Melting Powder Trapping by Vortex in the Continuous Casting Mold
- The Coordination of F Ions around Al and Ca Ions in Molten Aluminosilicate Systems
- The Role of Ca and Na Ions in the Effect of F Ion on Silicate Polymerization in Molten Silicate System
- The Estimation of the Iso-viscosity Lines in Molten CaF2–CaO–SiO2 System
- Occurrence Condition of a Swirling Bubbling Jet in a Water Bath Covered with an Oil Layer
- PRACTICAL APPLICATIONS OF SWIRLING JETS TO MIXING PROCESSES(Swirling Flow and Separation)
- FUNDAMENTAL CHARACTERISTICS OF SWIRLING JETS IN CYLINDRICAL VESSEL(Swirling Flow and Separation)
- Prediction of the Occurrence of Swirl Motion at Interface between Stratified Two Liquids
- Model Study on a Swirl Motion of a Bubbling Jet Generated in a Wastewater Bath Covered with Top Oil Layer
- Cold Model Study of the Effects of Density Difference and Blockage Factor on Mold Powder Entrainment
- Promotion of Uniform Dispersion of Fine Particles into a Mechanically Agitated Steel Bath
- The Effect of Grain Boundaries on the Surface Rearrangement during Wustite Reduction within its Range of Existence
- Measuring Strains for Hematite Phase in Sinter by Electron Backscattering Diffraction Method
- The Effect of Grain Boundaries on Iron Nucleation during Wustite Reduction Process
- Rupture Phenomena of Molten Alkali Silicate Thin Films
- Occurrence Condition for a Swirl Motion of a Bath Agitated by Bottom Gas Injection
- Fluid Flow in a Combined Top and Bottom Blown Reactor
- Swinging Motion of Bath Surface Induced by Side Gas Injection
- Effect of Density of Low-Density Particles on Their Dispersion Behavior under Mechanical Agitation
- Model Study of the Rupture Phenomena of a Metal Droplet Growing on a Slag-Metal Interface
- Prediction of the Occurrence of Swirling Liquid Jet
- Proposal of a Novel Agitation Method using Swirl Motion of Molten Metal Jet
- Processing of Refractory Organic Waste Water Using Ozone and Novel Agitation Method
- Mixing time in a cylindrical bath agitated by swirl motion of water jet
- Swirling Flow Effect in Off-center Immersion Nozzle on Bulk Flow in Billet Continuous Casting Mold
- Swirling Flow Effect in Submerged Entry Nozzle on Bulk Flow in High Throughput Slab Continuous Casting Mold
- Powder-Metallurgical Free-Form Microchanneling Process for Producing Metallic Microreactors
- Physical characteristics of a Horizontally Injected Gas Jet and Turbulent Flow in Metallurgical Vessels
- Effect of Initial Acceleration History on Transition to Turbulence in Pipe Flow
- Behavior of a Droplet on an Inclined Plate under Various Wettability Conditions
- Effects of Inner Nozzle Diameter and Hole Diameter on the Frequency of Bubble Formation from a Multi-hole Nozzle
- Microchanneling and Lining Layer Formation by Spontaneous Infiltration in Fe-Cu System
- Formation Mechanism of Microchannels and Lining Layers in Sintered Iron Powder Compacts with Copper Sacrificial Cores
- Velocity Measurement Behind a Circular Cylinder Placed Horizontally in Bubbling Jet
- Occurrence Process of Jet-Induced Rotary Sloshing in a Cylindrical Container
- Water Model Experiments on Mechanical Agitation for Hot Metal Pretreatment Process
- Relationship between Internal Flow and Fan Noise of Cross Flow Fan
- Some Aspects of the Amplitude of Swirl Motion of a Cylindrical Bath Induced by a Liquid Jet
- PE-087 Plasma pteridine level as a biomarker of cardiovascular diseases(Endothelium(02)(IHD),Poster Session(English),The 72nd Annual Scientific Meeting of the Japanese Circulation Society)
- FRS-104 Plasma Biopterin Levels as a Biomarker of Endothelial Dysfunction(Biomarker of Cardiovascular Disease, The 71st Annual Scientific Meeting of the Japanese Circulation Society)
- An Air Cavity Formed Behind a Poorly Wetted Sphere Penetrating into a Water Bath
- Spout Eye Area in Ladle Refining Process
- Model Experiments on the Mixing Time in a Bottom Blown Bath Covered with Top Slag
- Swirl Motions of Two Bubbling Jets Induced by Bottom Gas Injection
- Unsteady Motions of Cylindrical Bath Caused by Offset Bottom Gas Injection
- Gas-Liquid Mass Transfer in Simulated Turbulent Wake Flow
- Flow Patterns of Gas-Liquid Two-phase Flow through an Abrupt Expansion in Millimeter-Scale Rectangular Channel
- The Preferable Growth Direction of Iron Nuclei on Wustite Surface during Reduction
- Experiment on the Effect of Water Jet upon the Melting Process of an Ice Sphere in a Cylindrical Bath
- A bouncing droplet on an inclined hydrophobic surface
- A Method for Measuring Particle Size in Overlapped Particle Images
- Model Experiments on Transient Swirl Motion of a Wastewater Jet Generated by J-Shaped Lance
- Gas-Liquid Two-Phase Flow through at Orifice in Millimeter-Scale Rectangular Channel
- Steroid-induced Paraparesis: Spinal Epidural Lipomatosis Complicated by a Wedge Deformity of the Middle Thoracic Vertebrae