An Optimum Design and Fabrication of Focus Lens for High Intensity Light-Emitting Diodes

スポンサーリンク

概要

• 論文の詳細を見る

• A maximum output intensity of high-power light-emitting diodes (LEDs) with high-efficiency focus lens is demonstrated. A commercial software package of Trace Pro and one-factor method are used to simulate the focus lens. The optimum parameters of focus-lens design are the radius curvature, cavity depth, and lens height are 2.75, 2.45, and 5.7 mm, respectively. For the fabrication of focus lens with injection molding, the optimum parameters are simulated by adapting Taguchi’s method of the smaller-the better algorithm in a software package for Moldex 3D. By employing both optimum design and fabrication of the focus lens, a maximum peak intensity for 64.6 cd for a 1 W blue LED module was realized under a constant driving current of 320 mA and the voltage of 3.2 V. In comparison with a commercial focus lens used in high-power LEDs under the same test conditions, the high-power LEDs with proposed focus lens exhibits about 2–3 times improvement in the output intensity. This study may provide a practical guideline for design and fabrication of a high-efficiency focus lens used in high-intensity high-power LED modules.

• 2009-09-25

著者

• HUANG Chun-Chin

  Department of Mold and Die Engineering, National Kaohsiung University of Applied Science

• Cheng Wood-Hi

  Department of Photonics, National Sun Yat-sen University, Kaohsiung 804, Taiwan

• Tsai Chun-Chin

  Department of Photonics, National Sun Yat-sen University, Kaohsiung 804, Taiwan

• Wang Jimmy

  Department of Photonics, National Sun Yat-sen University, Kaohsiung 804, Taiwan

• Hsuh Ming-Chou

  Department of Mold and Die Engineering, National Kaohsiung University of Applied Science, Kaohsiung 814, Taiwan

• Huang Chun-Chin

  Department of Mold and Die Engineering, National Kaohsiung University of Applied Science, Kaohsiung 814, Taiwan

関連論文

• Predicting the Permeability and Tensile Properties of Multilayer Films from the Properties of the Individual Component Layers
• Adhesion, Permeability, and Mechanical Properties of Multilayered Blown Films Using Maleated Low-Density Polyethylene Blends as Adhesion-Promoting Layers
• Two-Dimensional Simulations on Heat Transfer and Fluid Flow for Yttrium Aluminium Garnet Single-Crystal Fiber in Laser-Heated Pedestal Growth System
• An Optimum Design and Fabrication of Focus Lens for High Intensity Light-Emitting Diodes

スポンサーリンク