波状ロール成形を施したＡｌ‐０．７３％Ｍｇ‐０．３８％Ｓｉ合金の集合組織
スポンサーリンク
概要
- 論文の詳細を見る
Randomization of texture in Al–0.73Mg–0.38%Si alloy has been attempted by applying the wavy roll-forming method. Rolls having a wavy-shaped surface with about 8 mm in wavelength and 3 mm in amplitude were used. Specimens were solution heat treated at 813 K for 10.8 ks. The specimen was heated at 623 K for 180 s, and then immediately wavy roll-formed. The specimen was heated again and wavy roll-formed with rotating at 90° in plane. This process was repeated 8 times, then the specimen was flattened using conventional flat rolls. Wavy roll-formed specimen at room temperature was also prepared. The roll-formed specimens were annealed and then cold-rolled at room temperature and finally annealed at 773 K for 1.8 ks. For comparison, conventional flat rolled specimens were also prepared at 623 K or room temperature. Textures formed in the specimens were analyzed by electron backscattered diffraction measurements. Grain sizes formed in the warm wavy roll-formed specimen was coarser than that in the warm rolled specimen in final annealing after cold rolling. However, grain refining was accompanied with randomization of texture in the specimen wavy roll-formed at room temperature.
- 一般社団法人 軽金属学会の論文
一般社団法人 軽金属学会 | 論文
- Mechanical and wear properties of SiC whisker/ADC12 aluminum alloy composites fabricated by die casting.
- Joining of aluminum and ceramics.
- タイトル無し
- Undercooling and solidification behavior of fluid clumps of second-poured melt of hypereutectic Al-Si alloy in Duplex Casting process.
- Change in apparent viscosity of stirred slurry during production of semi-solid hypereutectic Al-Si alloy by slurry-melt mixing process.