Ａｌ‐１７％Ｓｉ‐４．５％Ｃｕ‐０．５％Ｍｇ Ｐ／Ｍ合金の超塑性に及ぼす温度の影響
スポンサーリンク
概要
- 論文の詳細を見る
Al–17 mass%Si–4.5 mass%Cu–0.5 mass%Mg rapidly solidified powder metallurgy (RSP) alloy was prepared by hot extrusion method. High temperature tensile property of the alloy was investigated in the temperature range from 400 to 540°C. Typical superplastic behavior was observed at 500 and 520°C. The value of the maximum tensile elongation of the alloy tested at 500°C was about 380% with an initial strain rate of 10−2s−1. At 520°C, partial melting phenomena by solute segregation at some grain boundaries were induced, and the maximum elongation of about 390% was obtained at higher initial strain rate than the case at 500°C of 10−1s−1. The superplastic behavior at both the temperatures may be based on grain boundary sliding and accommodation mechanism. At 520°C, the liquid phase at grain boundaries may play the role of an accommodation helper, absorbing dislocations and relieving the stress concentration due to sliding.
- 一般社団法人 軽金属学会の論文
一般社団法人 軽金属学会 | 論文
- Mechanical and wear properties of SiC whisker/ADC12 aluminum alloy composites fabricated by die casting.
- Joining of aluminum and ceramics.
- タイトル無し
- Undercooling and solidification behavior of fluid clumps of second-poured melt of hypereutectic Al-Si alloy in Duplex Casting process.
- Change in apparent viscosity of stirred slurry during production of semi-solid hypereutectic Al-Si alloy by slurry-melt mixing process.