Manufacturing process of Shirasu/Aluminum FGM and its thermal conductivity.
スポンサーリンク
概要
- 論文の詳細を見る
Shirasu/Aluminum functionally gradient materials (FGMs) were successfully fabricated by centrifugal casting method, where Shirasu is volcanic eruptions accumulated over the south kyushu in Japan. Thermal conductivity of Shirasu/Aluminum FGM was measured by a comparative method in two directions, i. e. perpendicular and parallel to the gradient direction. The thermal conductivity was theoretically estimated using the equation derived by Bruggeman both on Shirasu/Aluminum FGMs and uniformly dispersed Shirasu/Aluminum composites. It has been found that the thermal conductivity of the Shirasu/Aluminum FGMs in the perpendicular direction to the gradient is larger than that in the parallel direction. The anisotropy in the thermal conductivity obtained by the experiment is found to be larger than that predicted by the calculation. Since the Shirasu/Aluminum FGM has a strong anisotoropy in the thermal conductivity, this FGM can be used as a good heat-insulating material, compared with the uniform composite which contains the same amount of Shirasu.
- 一般社団法人 軽金属学会の論文
一般社団法人 軽金属学会 | 論文
- Mechanical and wear properties of SiC whisker/ADC12 aluminum alloy composites fabricated by die casting.
- Joining of aluminum and ceramics.
- タイトル無し
- Undercooling and solidification behavior of fluid clumps of second-poured melt of hypereutectic Al-Si alloy in Duplex Casting process.
- Change in apparent viscosity of stirred slurry during production of semi-solid hypereutectic Al-Si alloy by slurry-melt mixing process.