Vacuum brazing of aluminum/titanium joints with aluminum filler metals.
スポンサーリンク
概要
- 論文の詳細を見る
A spread test on Ti-base metals and clearance filling test on Al/Ti joints were performed in relation to the composition of aluminum filler metals and surface area of getter materials. The spread area on Ti-base metals depends on the surface area of Ti in a brazing furnace due to an effective gettering action of Ti. Mg bearing brazing sheets are also effective getter materials. Al-10Si-Mg alloy is the most suitable filler metal for vacuum brazing of Al/Ti joints, and allows sound fillets at 600°C. Al-10 to 12.5Cu-5 to 8Sn and Al-20Ag-10Cu filler metals are also applicable at brazing temperatures 600° to 620°C. The joint strength is, however, only a half of that of Al-10Si-Mg filler metals.
- 一般社団法人 軽金属学会の論文
一般社団法人 軽金属学会 | 論文
- Mechanical and wear properties of SiC whisker/ADC12 aluminum alloy composites fabricated by die casting.
- Joining of aluminum and ceramics.
- タイトル無し
- Undercooling and solidification behavior of fluid clumps of second-poured melt of hypereutectic Al-Si alloy in Duplex Casting process.
- Change in apparent viscosity of stirred slurry during production of semi-solid hypereutectic Al-Si alloy by slurry-melt mixing process.