Compressive Strength of Coal:On the Mechanism of Fine Grinding of Coal

スポンサーリンク

概要

• 論文の詳細を見る

• The compressive strength have been measured on irregular shaped coals ranging from 0.1mm to 2.0mm particle size for low ash coals in Hokkaido. The results obtained from these experiments and those obtained from the silica ball-mill grinding test for the same coals are summerized as follows:<BR>1) There are linear relationships between mean compressive strength and mean particle size of coals, and the extent of the effect of particle size on the compressive strength increases with increase of H. I.(Hardgrove index) (Fig. 2 and Table 1)<BR>2) The size distribution of broken coals by static compression correlates to M. I. of coals tested.(Fig. 3)<BR>3) For coals showing high H. I. as Naie coal, the weakest link theory could be appricable to the compressive breakage of irregular shaped coals in the range of these particle size. However this theory should not be applicable to coals showing low H. I., because the amount of cracks and flaws in these coals are not so much.<BR>4) Rate of grinding, except for two coals, is approximately proportional to H. I.(Fig. 9)<BR>5) In case of ball-mill grinding, the mode of breakage of low coals under compressive stresses is taking place through breaking process among each coal particles. Under the same grinding condition, the size distribution pattern of ground coals varies with increasing H. I. from the surface grinding pattern to the bulk crushing pattern.<BR>6) Wear of silica balls in the ball-mill grinding decreases rapidly with increasing H. I. up to about 60, and then decreases slightly.(Fig. 10)

• 一般社団法人 日本エネルギー学会の論文

一般社団法人 日本エネルギー学会 | 論文

• Modifying Optical Texture of the Coke from Miike Coal
• Development of Petrochemical Industry with the Background of Iron Manufacturing Industry
• タイトル無し
• Study on Development of Waste Oil Combustion Burner for Energy Saving and Low-Pollution (II): Combustion of Waste Oil and Exhaust Emission Characteristics by Internal Mixing Twin-Fluid Atomizer:Combustion of Waste Oil and Exhaust Emission Characteristics
• Study on Development of Waste Oil Combustion Burner for Energy Saving and Low-Pollution (I): Atomization of High-Viscous Liquid Jet by Internal Mixing Twin-Fluid Atomizer:Atomization of High-Viscous Liquid Jet by Internal Mixing Twin-Fluid Atomizer

もっと見る

スポンサーリンク