Laminar-Turbulent Transition of an Inlet Boundary Layer in a Circular Pipe Induced by Periodic Injection (Shape of Isolated Turbulent Patches and Their Growth)

概要

論文の詳細を見る
The laminar-turbulent transition of a boundary layer induced by an injection of jet in the inlet region of a circular pipe was experimentally investigated. The jet was periodically injected radially from a small hole in the inlet region into the pipe flow. Axial velocity was measured by a hot-wire anemometer. The turbulence induced by the jet within the boundary layer developed into turbulent patches which then grew in the axial, circumferential and radial directions downstream. The shape of the patches shown by the intermittency factor in the diametrical plane was similar to the turbulent spot in the flat plate boundary layer. Their property became similar to the turbulent slug in the pipe flow developed downstream. The turbulent patches protruded from the boundary layer after they grew and reached the circumferential opposite side, although they stayed within the boundary layer as long as the shape was turbulent spot-like in the diametrical plane. The propagation velocity at the leading edge became faster than the bulk velocity, though it turned slower at the trailing edge. Therefore, the growth rate of its streamwise length varied downstream. The growth rate of the patches' circumferential length was smaller than that in the turbulent spot under zero pressure gradient and was almost the same as the spot under favorable pressure gradient.