Simulation of Rolling Contact Fatigue Strength for Traction Drive Elements
スポンサーリンク
概要
- 論文の詳細を見る
A simulation of the rolling contact fatigue strength of a traction drive element was proposed. The simulation can account for both the distribution of sizes of inclusions in the element material and the influence of traction forces at the element surface. The shear strength of the matrix structure surrounding an inclusion was estimated with an equation. The hardness distribution and the Weibull distribution of inclusion dimensions, which were necessary parameters to calculate the rolling contact fatigue strength, were determined by observation of an actual test specimen. And the rolling contact fatigue strength was compared with the distribution of shear stresses in a roller affected by traction forces. A simulation assuming the same traction coefficient as that in the experiment predicted a rolling contact fatigue strength of 810 MPa with a standard deviation of 39.2 MPa, which differed from the experimental value by only 2.5%. Simulations of the rolling contact fatigue strength were then carried out while varying the traction coefficient. The contact force resulting in failure was observed to fall as the traction coefficient increased and the torque capacity increased. Thus, the torque capacity increases with the traction coefficient, regardless of changes in the rolling contact fatigue strength.
著者
-
Kazama Toshiharu
Muroran Institute of Technology
-
MASUYAMA Tomoya
Tsuruoka National College of Technology
-
NARITA Yukihito
Muroran Institute of Technology
-
YAMANAKA Masashi
High Energy Accelerator Research Organization
-
OSAFUNE Yasuhiro
Muroran Institute of Technology
関連論文
- W-03 Practical Education for Engineering Students and Regional Citizens in Manufacturing and Engineering Design Center (cremo) at Muroran Institute of Technology(International Session-I)
- W-14 Fostering Engineers with Creative Power : Activities and Achievements of Manufacturing and Engineering Design Center(International Session)
- マイクロ圧縮機用液状バルブの高圧力北へ向けて研究
- マイクロ空気圧縮機用液状バルブに関する研究
- 2A1-F15 Development and Modeling of Double Spiral Propulsion Robot in Wetlands
- Simulation of Rolling Contact Fatigue Strength for Traction Drive Elements
- 2A2-L06 V-REP based dynamic simulation and analysis of a spiral -propulsion robot on wetlands(Mobile Robot with Special Mechanism)