Volcanic Eruption and Nature of the Pyroclastic Deposits
スポンサーリンク
概要
- 論文の詳細を見る
This article deals with the mechanism of eruption and transportation of the pyroclastic material and the nature of the resultant deposits from the geological standpoint.In Japan, the method of tephrochronology is best applied to pyroclastic deposits of the Quaternary central volcanoes and those related to the Krakatoan calderas. Most of the rocks are andesitic in composition with subordinate amount of basalt and dacite.Three modes of volcanic eruption may be distinguished: 1) projection of pyroclastic materials which form pyroclastic fall deposits, 2) eruption of pyroclastic flows, and 3) outflow of lava flows or extrusion of dome and spine. Table 1 shows characteristic features of the deposits formed by the three modes of volcanic eruption.Tephra, as originally defined by Thorarinsson, signifies only the air-fall pyroclastic materials and its relation to pyroclastic flow is not clear. In this article, all the pyroclastic materials directly connected with volcanic eruptions, irrespective of their origin (i. e. essential, accessory, or accidental) and of their mode of emplacement, are included in the term tephra. The chronology using the deposits of pyroclastic flows are included in the tephrochronology.The small-scale vesiculation occurring at or close to the top of the magma column results in the so-called Strombolian and Vulcanian eruptions. Larger scale vesiculation with longer time duration leads to the Plinian eruption. The greatest vesiculation takes place within the magma reservoir resulting in the formation of a depression caldera. The larger the size of eruption column, the more effective the sorting of the erupted pyroclastic fragments. The larger and denser particles fall first and closer to the vent while the smaller and more vesicular fragments fall farther away. Consequently the deposits of pyroclastic falls are well sorted and exhibit pronounced lateral regular grading in texture and composition. This is in strong contrast with the poorly sorted character of pyroclastic flow deposits, in which all particles travel en masse in a state of turbulent flow.Welding of the deposit is not uncommon in the pyroclastic flow deposits while it is rare in pyroclastic fall deposits except those deposited near the vents of basaltic eruptions.To reconstruct past eruptions from volcanic deposits, it may be necessary to establish definite correlation between stratigraphic units by which volcanic deposits are grouped and time duration by which specific eruptive activity is grouped. A single eruptive cycle, the deposits of which represent such a time unit, is defined as a series of eruptive events limited by fairly long intervals of quiescence. Historic examples indicate that the duration of a single eruptive cycle ranges from a day to several years in most cases. The intervening periods are generally far longer than the duration of single eruptive cycle.From many examples of single eruptive cycles, a rule has been established: the degree of vesiculation of magma gradually decreases toward the end of the cycle. This is expressed in successive eruption of pyroclastic fall, pyroclastic flow, and lava flow from the same vent in case of felsic magma, and of pyroclastic fall and lava flow in case of mafic magma, which fact may indicate that the original magma column responsible for the eruptive cycle was more enriched in volatiles in the upper part than the lower.The close correlation between the recorded sequence of single eruptive cycles and the reultant beds of volcanic materials is described for a few examples. The beds produced by a single cycle of witnessed eruption conformably superpose each other and do not include a layer representing weathering break. It is stressed that such a group of beds of volcanic ejecta, volcanic deposits of a single eruptive cycle, should be taken into account as a stratigraphic unit when precise tephrochronology is undertaken.
- 日本第四紀学会の論文