Centrifugal pump behavior in steady and transient two-phase flow.
スポンサーリンク
概要
- 論文の詳細を見る
In the event of a LOCA (loss-of-coolant accident) resulting from a hypothetical guillo-tine break in the suction line of the PLR (primary loop recirculation) pump for a BWR plant, the PLR pump will be reversely driven by the two-phase fluid flowing back at high speed in the line. For clarifying the two-phase flow characteristics of the PLR pump, which would be necessary for the analysis of pump behavior during LOCA, blowdown tests were conducted using three scale model pumps. The two-phase flow characteristics data for the pump were plotted with use of homologous curves method and the two-phase degradation multiplier in order to examine the effect of specific speed and void fraction. As a result of this study, it was shown that the characteristics of any pump with specific speed between N<SUB>s</SUB>=500 and 4, 200 rpm•gpm<SUP>1/2</SUP>/ft<SUP>3/4</SUP> can be obtained by interpolation. Experimental analyses were made using the TRAC code. Analytical results regarding pump inlet pressure, void fraction, volumetric flow rate and pump speed showed good agreement with the test results. This is a joint study of Japan BWR utilities and plant makers.
- 一般社団法人 日本原子力学会の論文
著者
-
Narabayashi Tadashi
Nuclear Engineering Lab. Toshiba Corp.
-
AMANO Osamu
The Tokyo Electric Power Co., Inc.
-
AMANO Osamu
The Tokyo Electric Power Co.
-
ARAI Kenji
NAIG Nuclear Research Laboratory, Nippon Atomic Industry Group Co., Ltd.,
-
KUBOKOYA Takashi
Isogo Engineering Center, Toshiba Corp.
-
GOMYO Toshie
The Tokyo Electric Power Co., Inc.
-
GOMYO Toshie
The Tokyo Electric Power Co.
-
ARAI Kenji
NAIG Nuclear Research Laboratory, Nippon Atomic Industry Group Co., Ltd.
関連論文
- Safety Relief Valve Performance for Two-Phase Flow
- Analytical Study on Steam Jet Injector Pump to Next-Generation BWR
- Measurement of Void Distribution in Transient Flows
- Improvement of Precoat Type Condensate Filter Performance.
- Two-phase flow phenomena in broken recirculation line of BWR.
- Centrifugal pump behavior in steady and transient two-phase flow.
- Boiling water reactor loss-of-coolant tests with two bundle loop. Examination of conservativeness for licensing analysis models using large break test data.:Examination of Conservativeness for Licensing Analysis Models Using Large Break Test Data
- Estimation of centrifugal pump head in steam-water two-phase flow.