Post Irradiation Examination of High Burnup PWR Fuel.

概要

論文の詳細を見る
Post irradiation examination (PIE) of a high burnt lead fuel assembly. which was irradiated to demonstrate fuel integrity at high burnup, was performed before the start of the full batch loading of high burnup fuel of 48GVid/t maximum fuel assembly burnup.<BR>The lead fuel assembly was 17×17 B-type PWR fuel which was supplied by Nuclear Fuel Industries, Ltd. (NEI) and achieved the maximum burnup of 45 GWd/t after 4 cycles of irradiation in Ohi Unit 1 of the Kansai Electric Power Co. Inc. (Kansai).<BR>Twelve fuel rods extracted from the lead fuel assembly at the reactor site were examined at the hot-cell facility of Japan Atomic Energy Research Institute (JAERI) in Tokai-mura.<BR>Visually, the fuel rods appeared to be in good conditions, but some small spallings were observed at the second span from the top where oxide film was relatively thicker than other spans. Even in this span. the maximum oxide film thickness was less than 50 μm. Fission gas release rate was less than 1%. which caused only a small increase in fuel rod internal pressure. Mechanical properties of the fuel cladding were evaluated by tensile tests.<BR>These PIE results were within the range of other PIE data previously obtained from domestic and foreign PWR fuel rods. The data confirmed that the integrity of B-type fuel would be maintained at least up to 48GWd/t.
一般社団法人日本原子力学会の論文