Development of Small-Scale CHP Plant with a Wood Powder-Fueled Stirling Engine

概要

論文の詳細を見る
Small-scale biomass CHP (combined heat and power) plants are in demand for environmental reasons - particularly systems fueled by wood waste, which are simple to operate and require no maintenance while having high thermal efficiency similar to oil-fired units. A 55kWe Stirling engine CHP system, combined with a simplified biomass combustion process that uses pulverized wood powder has been developed to meet these requirements. Wood powder of less than 500 μm was mainly used in these tests, and a combustion chamber length of 3 m was applied. Under these conditions, the air ratio can be reduced to 1.1 without increasing CO emissions by less than 10 ppm, and with combustion efficiency of 99.9%. Under the same conditions, NOx emissions are estimated to be less than 120 ppm (on the basis of 6% O2). Wood powder was confirmed to have excellent properties as a fuel for Stirling engines. The 55 kWe Stirling engine performance test was carried out to optimize the operating condition of wood powder burners. The status of Stirling engine operation at a full load with 55 kWe was stable, and start-up and shut -down operations were easy to perform. Operational status was evaluated as being excellent, except for an ash fouling problem in the Stirling engine heater tubes. Ash fouling characteristics were considered in the final stage of the demonstration test. This paper summarizes the wood powder combustion test and Stirling engine performance test. Furthermore, the ash fouling data is shown and the mechanism of ash fouling in heater tubes is discussed.

Development of Small-Scale CHP Plant with a Wood Powder-Fueled Stirling Engine

スポンサーリンク

概要

著者

関連論文

スポンサーリンク