有限要素法による金型冷却設計
スポンサーリンク
概要
- 論文の詳細を見る
To clarify the effect of the cooling using a fountain type cooling pipe on the die temperature, the die temperature was calculated with the three-dimensional finite element method. From the calculation, the following results were obtained. (1) The value of surface temperature of die for one casting cycle without the cooling was about 310℃, and that increased about 10℃ from the value of initial temperature of die (300℃). Further, the value of surface temperature of die for ten casting cycles without the cooling was about 343℃. (2) The value of surface temperature of die at the center of a fountain type cooling pipe for one casting cycle with the cooling and that for ten casting cycles with the cooling were about 297℃ and 322℃, respectively, and these were lower than those without the cooling. The effect of the cooling on the die temperature was recognized.
- 呉工業高等専門学校の論文
呉工業高等専門学校 | 論文
- 材料表面における損傷検出システムに関する基礎的研究
- コンクリート表面におけるひびわれの定量評価に関する研究
- 『犬百人一首』全注釈(二)二十四〜五十五首
- 『犬百人一首』全注釈(一)一〜二十三首
- 大気圧水素混合ヘリウムグロー放電の気体温度と電子密度の測定