動力伝達用プラスチック歯車に関する研究(歯面温度に関する考察)
スポンサーリンク
概要
- 論文の詳細を見る
Until now, the decrease of mechanical strength owing to temperature rising is attached great importance as the most important factor to decide the life cycle (wear, breakage) of plastic gears for power transmisson. But, there is few example that tooth flank temperature is actualy measured. Also, the relation between tooth flank temperature and tooth damage is not examined enough. In this report, tooth flank temperature of plastic gears is measured in detail by usig a radiation pyrometer and the results are obtained as follows: 1. When module is large, average temperature of working flank is high and that the difference of maximum and minimum temperature is large. 2. Pitch point does not always take maximum temperature, there are some cases in which tooth flank temperature is influenced by the interference by teeth of steel gears. 3. Cooling effect of teeth by rotation is affected by gear operating position (driver or follower) and combination of gear materials. 4. It is very effective for preventing temperature rising to cool forcibly the tooth of plastic gears. So, if forced cooling is applied, extention of life cycle can be expected. 5. Breakage point of plastic gear teeth does not always coincide with maximum temperature point.
- 長崎大学工学部,Faculty of Engineering, Nagasaki Universityの論文
著者
関連論文
- ボブ刃形輪郭の計算法(第5報) : 取付誤差とすくい角誤差の影響
- ホブ刃形輪郭計算における干渉問題の処理
- 歯車の騒音・振動計測における平均成分の抽出法(第2報) : 波形収録中の歯車回転数変動の影響
- 魚類の摂餌音の誘引効果について
- 歯車の騒音・振動計測における平均成分の抽出法
- 水中生物音のFFT解析上の問題点と対策
- 成形研削によるはすば歯車の歯面修整加工
- 成形研削によるはすぱ歯車加工時の砥石セッティング誤差推定法
- 成形研削によるはすば歯車の歯筋修整加工
- A Profile Calculation Method for Form Grinding Wheels -Theoretical Analysis of Error Transmission and its Application-
- 3軸マシニングセンタにおいて工具が描く3次元包絡面の算出
- 成形研削用砥石輪郭の計算法(第2法) : 誤差伝播解析とその応用
- 成形研削用砥石輪郭の計算法(第1報) : 歯車研削用砥石と干渉防止
- 動力伝達用プラスチック歯車に関する研究(歯面温度に関する考察)
- プラスチック歯車の動力伝達時歯面温度分布の計測