Control method for a combined active filter system employing a current source converter and a high pass filter
スポンサーリンク
概要
- 論文の詳細を見る
This paper describes a control method with a combined filter system which senses load current, source current, and line voltage to create reference signals for an active filter. The transfer function of the active filter is identified and is used for the control system design. It is shown that the source current feedback is most effective in suppressing the harmonic-enlarging effects due to parallel resonance and the harmonic current generated by source harmonic voltages. A small setup controlled by a DSP was built, and the validity of the proposed method was demonstrated by experimental results
- IEEEの論文
IEEE | 論文
- Magnetic and Transport Properties of Nb/PdNi Bilayers
- Supersonic Ion Beam Driven by Permanent-Magnets-Induced Double Layer in an Expanding Plasma
- Surfactant Adsorption on Single-Crystal Silicon Surfaces in TMAH Solution: Orientation-Dependent Adsorption Detected by In Situ Infrared Spectroscopy
- Extended-range FMCW reflectometry using an optical loop with a frequency shifter
- Teachingless spray-painting of sculptured surface by an industrial robot