J122021 熱変形を考慮した複合材料補強パネルの積層構成最適化の基礎的研究([J12202]解析・設計の高度化・最適化(2))

概要

論文の詳細を見る
This paper discusses optimum design of a stiffened composite panel: the panel is widely used for weight reduction in aerospace structures. Anisotropic thermal expansion coefficients of the composite laminates causes complicated deformation of the panel after the curing. . In previous researches of the stacking sequence optimizations, the optimizations were performed without considering thermal deformation: a response surface was used to obtain an objective function at low computational cost, and lamination parameters were sued as variables for the response surface of the objective function such as buckling load ratio. However, the thermal deformation caused by the temperature change after curing must be considered as a constraint factor for actual composite structures. In the present study, therefore, thermal deformation is dealt with as a constraint for a stacking sequence optimization problem. Three surrogate models of the thermal deformation are discussed here: a conventional method using lamination parameters; a new method using lamination parameters and thermal coefficients; a modified new method As a result, the modified new method is shown to be effective for the surrogate model.
一般社団法人日本機械学会の論文
2011-09-11