C34 Examination of Method of Quantification of Dynamic Characteristic Parameters of Tooling System Based on Impulse Response(Evaluation of machine tool performance)

スポンサーリンク

概要

• 論文の詳細を見る

• In this study, the new quantification method of the dynamic characteristic parameters of the tooling system is proposed, and then, its validity and utility are examined based on the experiment and the theoretical analysis. By extracting of the single mode element of vibration waveform and correcting the discretization error, the dynamic characteristic parameters can be quantified correctly compared with the conventional method. From the applied results, the influence of the difference in the structure on dynamic stiffness of tooling system can be explained based on the physical parameters such as equivalent stiffness and equivalent damping coefficient.

• 一般社団法人日本機械学会の論文
• 2009-12-01

著者

• SHIMIZU Shinji

  Dept. of Mechanical Engineering, Faculty of Science and Technology, Sophia University

• Shimizu Shinji

  Dept. Of Engineering And Applied Sciences Sophia University

• SAKAMOTO Haruhisa

  Dept. of Engineering and Applied Sciences, Sophia University

• MATSUDA Taiga

  Graduate School of Science and Technology, Sophia University

• Matsuda Taiga

  Graduate School Of Science And Technology Sophia University

• Sakamoto Haruhisa

  Dept. Of Engineering And Applied Sciences Sophia University

関連論文

• New Measuring Method for Thermal Deviations Caused by Linear Axis Motion in Multi-task Machine(Evaluation of machine tool performance)
• C34 Examination of Method of Quantification of Dynamic Characteristic Parameters of Tooling System Based on Impulse Response(Evaluation of machine tool performance)

スポンサーリンク