GDN-03 CHARACTERIZATION OF MESH EXCITATION FORCE WAVEFORM WITH VIBRATION MEASUREMENT ON POWER TRANSMISSION CASE(DYNAMICS AND NOISE PROBLEMS OF GEARS AND GEAR BOXES)
スポンサーリンク
概要
- 論文の詳細を見る
Tooth surface form inspection is generally performed for quality check of gears. But inspection of single gear can't estimate gear pair's characteristic, effect of alignment error, elastic deformation of shafts and gearbox. Therefore, inspection method not for single gear but for gear unit is desirable. Authors had proposed the method that estimate frequency response function(FRF) of a gear system with vibration measurement. It enables to obtain mesh excitation force and to estimate surface form characteristics. In the proposed study, vibration signal is measured on gear body. But mounting vibration transducers on rotating gear costs expensive for practical use on quality check, diagnosis, etc. In this study, we discuss about FRF estimation with vibration measurement on pedestal.
- 一般社団法人日本機械学会の論文
- 2009-05-13
著者
-
OHSHIMA Shun-ichi
Precision and Intelligence Laboratory, Tokyo Institute of Technology
-
Houjoh Haruo
Precision Alld Intelligence Laboratory Tokyo Institute Of Technology
-
Ohshima Shun-ichi
Precision And Intelligence Laboratory Tokyo Institute Of Technology
-
MATSUMUR Shigeki
Precision and Intelligence Laboratory, Tokyo Institute of Technology
-
RATANASUMAWONG Chanat
Mechanical engineering department,Chulalongkon University
-
Matsumur Shigeki
Precision And Intelligence Laboratory Tokyo Institute Of Technology
-
Ratanasumawong Chanat
Mechanical Engineering Department Chulalongkon University
関連論文
- Sound Field Assessment by Measurement of Sound Pressure Distribution Close to Machine Noise Source : Estimation of Normal Particle Velocity at an Aperture by Single-Plane Sound Pressure Measurement
- Vibration and Sound-Radiation Analysis for Designing a Low-Noise Gearbox with a Multi-Stage Helical Gear System
- SOUND-RADIATION ANALYSIS FOR DESIGN OF A LOW-NOISE GEARBOX WITH A MULTI-STAGE HELICAL GEAR SYSTEM
- Rotational Vibration of a Helical Gear Pair Having Tooth Surface Deviation during Transmission of Light Load
- GDN-25 ESTIMATION OF DAMPING COEFFICIENTS ON A POWER TRANSMISSION SYSTEM USING MODAL ANALYSIS(GEAR DYNAMICS AND NOISE)
- GDN-02 DYNAMIC CHARACTERIZATION OF ASYMMETRICAL SIDEBANDS OF MESH FREQUENCY(DYNAMICS AND NOISE PROBLEMS OF GEARS AND GEAR BOXES)
- 107 DESIGNING A LOW-NOISE GEARBOX BY USING VIBRATION AND SOUND-RADIATION ANALYSIS OF A GEAR SYSTEM(O.S.2 Vibration and Noise Reduction Technology II)
- GDN-03 CHARACTERIZATION OF MESH EXCITATION FORCE WAVEFORM WITH VIBRATION MEASUREMENT ON POWER TRANSMISSION CASE(DYNAMICS AND NOISE PROBLEMS OF GEARS AND GEAR BOXES)
- Behavior of Aerodynamic Sound of Spur Gears : Determination of Similarity Law and Source Locations
- Inspection of Tooth Surface Geometry by Means of Vibration Measurement : Assessment of Tooth Surface Undulation from Synchronous Averaged Signal and Application of Frequency Response Function
- GDN-15 PREDICTION OF GHOST NOISE OCCURRENCE ON GROUND HELICAL GEARS WITH DETAILED SURFACE MEASUREMENT(GEAR DYNAMICS AND NOISE)
- Radiation Mechanism for the Aerodynamic Sound of Gears : An Explanation for the Radiation Process by Air Flow Observation
- Estimation of Sliding Loss in a Parallel-Axis Gear Pair