GM-03 CUTTING OF FACE GEAR FOR HIGH REDUCTION GEAR DRIVES(MANUFACTURING OF GEARS)
スポンサーリンク
概要
- 論文の詳細を見る
This paper describes cutting methods for a face gear meshing with a large helix pinion with a small number of teeth. This type of face gear may be cut with the hob having the same profile of the pinion. But, it is known that interference between the hob tooth flank and gear blank and the profile error based on a cutter feed are apt to occur. In this paper, mechanisms that the interference and the profile error occur are investigated numerically. And, the cutting conditions for no interference and smaller profile errors are shown. Cutting tests of the face gear were conducted on the hobbing machine with a tangential feed attachment. Moreover, meshing tests were conducted using the face gear cut by applying the proposed method. As the results, good contact patterns with smooth meshing were obtained.
- 一般社団法人日本機械学会の論文
- 2009-05-13
著者
-
Yoshino Hidehiro
Department Of Mechanical Systems Engineering Saga University
-
Yoshino Hidehiro
Department Of Mechanical Engineering Saga University
-
OHSHIMA Fumihiro
Department of Mechanical Engineering, Saga University
-
Ohshima Fumihiro
Department Of Mechanical Systems Engineering Saga University
-
Ohshima Fumihiro
Department Of Mechanical Engineering Saga University
関連論文
- GDS-8 IDEAL TOOTH SURFACE MODIFICATION METHOD FOR CYLINDRICAL WORM GEARS(GEAR DESIGN AND SYNTHESIS)
- GM-10 DEVELOPMENT OF RELIEF GRINDING SYSTEM FOR HOB FINISHING(GEAR MANUFACTURING)
- GM-08 STUDY ON RELIEF GRINDING OF PINION CUTTER WITH TRAPEZOID WHEEL(MANUFACTURING OF GEARS)
- GM-03 CUTTING OF FACE GEAR FOR HIGH REDUCTION GEAR DRIVES(MANUFACTURING OF GEARS)
- GM-9 DEVELOPMENT OF MULTI-PURPOSE FORM GEAR GRINDING MACHINE(GEAR MANUFACTURING)