I-7 IDENTIFICATION OF SURFACE ROUGHNESS USING LAMB WAVES(Session: Molding/Roughness/Mechanical)

スポンサーリンク

概要

• 論文の詳細を見る

• Wear is a cause of failure in many engineering components especially involving high speed movement. Wear normally related to the surface roughness of the material and it's rate is high when two rough surfaces are in relative motion. Surface roughness of the material is commonly be measured using stylus profilometer. However there is limitation using of this method due location of the surface is inside the machine. The experimental work done with 250 kHz as an input frequency propagates through various artificial surface roughnesses, and then all responses are recorded. Results show that frequency of 250 kHz give a high potential in surface roughness identification.

• 一般社団法人日本機械学会の論文
• 2006-11-08

著者

• Wan Mohamed

  Faculty Of Mechanical Engineering University Teknologi Mara

• Ismail Muhammad

  Faculty Of Mechanical Engineering University Teknologi Mara

• Ismail Muhammad

  Faculty Of Mechanical Engineering Universiti Teknologi Mara

• Abdullah Nik

  Faculty of Mechanical Engineering, Universiti Teknologi MARA

• Abdullah Nik

  Faculty Of Mechanical Engineering University Teknologi Mara

• Abdullah Nik

  Faculty Of Mechanical Engineering Universiti Teknologi Mara

関連論文

• A-22 DENSIFICATION BEHAVIOUR OF INCINERATOR BOTTOM ASH (IBA) USING POWDER COMPACTION METHOD(Session: Inorganic Materials)
• I-7 IDENTIFICATION OF SURFACE ROUGHNESS USING LAMB WAVES(Session: Molding/Roughness/Mechanical)

スポンサーリンク