I-6 RAPID MOLDING USING AN EPOXY RESIN COMPOSITE(Session: Molding/Roughness/Mechanical)
スポンサーリンク
概要
- 論文の詳細を見る
This paper investigates the possibility of creating an insert mold using an epoxy resin composite (aluminum, resin and hardener). The properties of epoxy resin composite and rapid tooling techniques are studied and discussed. The results indicate that the insert mold made from this material can be assembled with a standard mold base and is compatible with an injection molding process without any further modifications required. The operating test also revealed no significant damage to the mold. One limitation of this composite, however, is its poor thermal conductivity.
- 一般社団法人日本機械学会の論文
- 2006-11-08
著者
-
Unnanon Kittinan
National Metal And Materials Technology Center
-
Unnanon Kittinan
National Metal And Material Technology Center(mtec) National Science And Technology Development Agen
-
Ariyatum Busayawan
National Metal and Materials Technology Center
-
Nakngoenthong Jiradech
National Metal and Materials Technology Center
-
Phuchamnong Anek
National Metal and Materials Technology Center
-
Soparat Jenwit
National Metal and Materials Technology Center
関連論文
- J-3 An Application of Computer Aided Design and Computer Aided Engineering for the Optimized Condition on Rubber Injection Moulding(Session: Interface/FEM/CAE)
- I-6 RAPID MOLDING USING AN EPOXY RESIN COMPOSITE(Session: Molding/Roughness/Mechanical)
- I-5 RAPID MOLDING USING THE SELECTIVE LASER SINTERING (SLS) TECHNIQUE(Session: Casting/Molding)