C-11 FABRICATION OF AL-FE ALLOYS BY REPEATED COMPACTION AND EXTRUSION OF MIXTURE OF ELEMENTAL POWDERS(Session: EDM/MIM)

スポンサーリンク

概要

• 論文の詳細を見る

• Al-Fe alloys with composition 1.0, 2.5, 5.0at.%Fe are fabricated by repeated compaction and backward extrusion in a closed die set using raw materials as elemental powder mixture. This process is done in solid state. The produced alloyed preforms are further consolidated by Hot Forging to achieve high density billet. Alloyed preforms are tested for thermal stability by using differential thermal analysis. Phase changes during heating are investigated by using x-ray diffraction, and confirmed by scanning electron microscope using EDS line scan mode. The alloyed billets are subjected to tensile test.

• 一般社団法人日本機械学会の論文
• 2006-11-08

著者

• LUANGVARANUNT Tachai

  Department of Metallurgical Engineering, Faculty of Engineering, Chulalongkorn University

• THRERUJIRAPAPONG Thotsaphon

  Department of Mechanical Engineering, Graduate School of Engineering, Osaka University

• Kondoh Katsuyoshi

  Functional Materials Laboratory Rcast University Of Tokyo

• Threrujirapapong Thotsaphon

  Department Of Metallurgical Engineering Chulalongkorn University

• Danchaivijit Sawai

  Department of Metallurgical Engineering, Chulalongkorn University

• Luangvaranunt Tachai

  Department Of Metallurgical Engineering Chulalongkorn University

• Danchaivijit Sawai

  Department Of Metallurgical Engineering Chulalongkorn University

関連論文

• Aluminum-4 mass% Copper/Alumina Composites Produced from Aluminum Copper and Rice Husk Ash Silica Powders by Powder Forging
• Mechanical Properties of a Titanium Matrix Composite Reinforced with Low Cost Carbon Black via Powder Metallurgy Processing
• C-11 FABRICATION OF AL-FE ALLOYS BY REPEATED COMPACTION AND EXTRUSION OF MIXTURE OF ELEMENTAL POWDERS(Session: EDM/MIM)
• New Process to Fabricate Magnesium Composites Using SiO_2 Glass Scraps
• Fabrication of Al-Fe Alloys by Repeated Compaction and Extrusion of Mixture of Elemental Powders

スポンサーリンク