Cause of Cutting Forces Decrease in the Cutting with Built-up Edge

スポンサーリンク

概要

• 論文の詳細を見る

• The reduction mechanism of cutting forces in the cutting with built-up edge (BUE) is investigated by carrying out the orthogonal cutting tests for the aluminum alloy. The behaviors of cutting forces in the cutting with BUE are compared with those in the cutting with rake face length restricted. It is found that the remarkable decrease of cutting forces is caused by not only the well-known increase of effective rake angle of BUE but also by the effect of restricting tool-chip contact length.

• 北海道工業大学の論文
• 2007-03-26

著者

• Yoshida Kanou

  Hokkaido Inst. Technol.

• Yoshida Kanou

  Hokkaido Institute Of Technology

関連論文

• Cause of Cutting Forces Decrease in the Cutting with Built-up Edge
• Relationship between the Effect of Restricting Tool-Chip Contact Length and the Cutting Process with Built-up Edge
• Basic Study of Machining Error in the Side Cutting by End Milling
• Influence of Formation of Subsurface Layer in the Machined Surface onFriction Process at Tool Rake Face.

スポンサーリンク