Microstructure and Mechanical Properties of Magnetron Sputtered (Ti, Al)N Coatings with fcc Structure(Properties(structural and functional)<Special Issue>Guest Editors Dedicated to Prof. Gunter Petzow: Modern Trends in Advanced Ceramics)

スポンサーリンク

概要

• 論文の詳細を見る

• Magnetron sputtered (Ti_<0.55>, Al_<0.45>) N and (Ti_<0.34>, Al_<0.66>) N coatings are deposited onto cemented carbide substrates at 350℃. The crystal structure and microstructure of the deposited coatings are characterized by means of X-ray diffraction (XRD), electron probe microanalysis(EPMA), scanning electron microscopy(SEM), and transmission electron microscopy(TEM). Nanoindentation is employed to determine the microhardness of the coatings. The adhesion between the coating and substrate is investigated using scratch test. Measurement of flank wear is used to evaluate the wear resistance of the coatings. XRD examination indicates that both (Ti_<0.55>,Al_<0.45>) N and (Ti_<0.34>, Al_<0.66>) N coatings are of fcc structure. The atomic ratios of Al against Ti for the two coatings are approximately close to those of the alloy targets according to EPMA measurement. In accordance with SEM observation, the fractured cross-section of (Ti_<0.55>, Al_<0.45>) N coating is characterized by dense columnar grain structure with most of grains extending from the interface of coating and substrate to the surface. SEM and TEM investigations show that the (Ti_<0.34>, Al_<0.66>) N coating indicates the nano-crystalline feature without appearance of the columnar structure. (Ti_<0.34>, Al_<0.66>) N coating exhibits higher microhardness and wear resistance, but lower adhesion with the substrate than (Ti_<0.55>, Al_<0.45>) N coating.

• 社団法人日本セラミックス協会の論文
• 2006-11-01

著者

• Du Yong

  State Key Laboratory Of Powder Metallurgy Central South University

• CHEN Li

  State Key Laboratory of Powder Metallurgy, Central South University

• WANG Shequan

  State Key Laboratory of Powder Metallurgy, Central South University

• XU Honghui

  State Key Laboratory of Powder Metallurgy, Central South University

• Wang Shequan

  State Key Laboratory Of Powder Metallurgy Central South University:zhu Zhou Cemented Carbide Cutting

• Chen Li

  State Key Laboratory Of Powder Metallurgy Central South University

• Chen Li

  State Key Laboratory Of Chemo/biosensing And Chemometrics College Of Chemistry And Chemical Engineering Hunan University

関連論文

• Crystallization of Al_2FeZr_6 Amorphous Alloy Prepared by Mechanical Alloying
• Microstructure and Mechanical Properties of Magnetron Sputtered (Ti, Al)N Coatings with fcc Structure(Properties(structural and functional)Guest Editors Dedicated to Prof. Gunter Petzow: Modern Trends in Advanced Ceramics)
• Preparation of graphite@Cu powders from ultrasonic powdering technique

スポンサーリンク