Application of DLC Coating to Ironing Die(<Special Issue>Recent Advances in Materials and Processing (I))

スポンサーリンク

概要

• 論文の詳細を見る

• The possibilities of application of DLC-Si coating to the die in dry ironing process have been investigated by strip-ironing type tribometer. Alloy tool steel and high speed steel were used as substrate material for ironing dies. Two types of substrate surface texture were prepared by lapping and grinding. And two types of die edge angle were prepared. High tensile strength steel and brass were tested as workpieces. The surface appearance of die, friction coefficient during ironing and surface roughness of ironed workpiece were measured. The friction coefficient of DLC-Si coated die in the dry ironing process is relatively low. Galling does not occur on the die surface. In case of high tensile strength steel, the damage grows with the number of tests. The surface roughness of a brass workpiece does not increase with repeat ironing. The DLC-Si coating could be applied to the dry ironing process in this investigated condition.

• 2005-10-15

著者

• Kubota Hiroyuki

  Gifu University

• Dohda Kuniaki

  Department Of Mechanical Engineering Gifu University

• Tsuchiya Yoshinari

  Metallic Material Lab. Toyota Central R&d Labs. Inc.

関連論文

• Application of DLC Coating to Ironing Die(Recent Advances in Materials and Processing (I))
• Effect of Lubrication on the Improvement of Uniformity in Uniaxial Powder Compaction(Recent Advances in Materials and Processing (I))
• Development of Tribology in Metal Forming
• 307 Hollow Spline Shaft Manufactured by Deep Drawing and Extruding Thick Plate

スポンサーリンク