Study on groove wear in finish turning of steels
スポンサーリンク
概要
- 論文の詳細を見る
Finish-turning tests by carbide tool are performed using various cutting fluids, argon gas and workmaterials with different hardness, to investigate the cause of groove wear occurrence from various points of view through detailed observation of grooving. From the experiments, the followings are attained. (1) Groove wear is caused by the following two reasons; 1) Work-hardening of surface layer of workpiece 2) Partial decrease of wear resistance of tool (2) Cutting fluids are very effective in the decrease of grooving. Particularly, spindle oil having a moderate permeability and lubricant ability gives prominent effects on it.
- 山口大学の論文
著者
-
FUJITA TAKEO
Department of Cancer and Thoracic Surgery, Okayama University Graduate School of Medicine and Dentis
-
Fujita Takeo
Department Of Mechanical Engineering Technical Junior College Of Yamaguchi University
-
Fujita Takeo
Department Of Cancer And Thoracic Surgery Okayama University Graduate School Of Medicine And Dentist
関連論文
- Anaplastic Thyroid Carcinoma Associated with Granulocyte Colony-Stimulating Factor : Report of a Case
- Intraoperative Prediction of Compensatory Sweating for Thoracic Sympathectomy
- Long-term survival of a patient with advanced adenosquamous carcinoma of the gallbladder after radical resection
- Rectal adenocarcinoma metastatic to the thyroid gland
- Clinicopathological relevance of UbcH10 in breast cancer
- Solitary Cranial Metastasis of Thyroid Carcinoma 13 Years After Primary Surgery : Report of a Case
- Bilateral angiosarcoma of the breast detected by magnetic resonance imaging during pregnancy
- Study on groove wear in finish turning of steels
- An Approach to Simulation of Practical Process By Analog Computer
- Influences of water base cutting fluids on tool wear at low cutting speed in turn of carbon steels