Synthesis and Characterization of SiC Ceramics for High Temperature Resistant Coatings and Matrix
スポンサーリンク
概要
- 論文の詳細を見る
SiC ceramics are expected as oxidation resistant coating material for Carbon/Carbon (C/C) composites. In the present study, SiC ceramics were synthesized through Sol-Gel method with low environmental impact. The gels were synthesized from ethylalcohol, methyltriethoxysilane (MTES), hydrochloric acid (HCl) and purified water (H_2O), and it was pyrolyzed at 1000, 1500 and 1700℃. The structures of gels after heat treatment were analyzed by X-ray diffraction (XRD). XRD results indicated that β-SiC were obtained in the present method and crystallization was increased with increasing heat treatment temperature. There was little weight change in synthesized SiC obtained at 1000℃ in air, which results in lower weight changes in SiC coated C/C composites comparing with bare C/C composites. However, SiC coated C/C composites were also oxidized because of the generation of cracks during heat treatment at 1000℃. Residual tensile strength of SiC coated C/C composites were also higher than that of bare C/C composites after 5 minutes oxidation.
- 一般社団法人日本機械学会の論文
- 2006-04-15
著者
-
WATANABE Hiroyuki
Graduate School of Agriculture, Kyoto University
-
KOBAYASHI Satoshi
Graduate School of Science and Engineering, Tokyo Metropolitan University
-
Wakayama Shuichi
Graduate Student Tokyo Metropolitan University
-
Wakayama Shuichi
Graduate School Of Engineering Tokyo Metropolitan University
-
Kobayashi Satoshi
Graduate Student Tokyo Metropolitan University
-
Fukushima Manabu
Aist
-
Watanabe Hiroyuki
Graduate School Of Agriculture Kyoto University
-
Watanabe Hiroyuki
Graduate Student Tokyo Metropolitan University
-
Kobayashi Satoshi
Graduate School Of Engineering Tokyo Metropolitan University
関連論文
- Expansion of Farm Forestry in Northern Vietnam : A Case Study from Yen Lap District, Phu Tho Province
- Interfacial Shear Strength Evaluation of Jute/Poly(Lactic Acid)
- The abundance and composition of arboreal arthropods in Acacia mangium and Paraserianthes falcataria plantations in South Sumatra, Indonesia
- Synthesis and Characterization of SiC Ceramics for High Temperature Resistant Coatings and Matrix
- Improvement of the burst strength of FW-FRP composite pipes after impact using low-modulus amorphous carbon fiber
- Characterization of MgO Thin Films Grown on Carbon Materials by Molecular Beam Epitaxy
- Damage Behavior of Hemp Fiber Reinforced Poly(L-Lactic Acid) Composites under Fatigue Loading
- Characterization of MgO Thin Films Grown on Carbon Materials by Molecular Beam Epitaxy
- The Effect of Hydrolysis on the Mechanical Properties of Injection-Molded Poly(L-lactic acid)