Load Distribution and Tooth Root Stress of Bevel Gears

スポンサーリンク

概要

• 論文の詳細を見る

• Determining the load distribution on a contact line of a bevel gear and the tooth root stress distribution are very important on strength design.However, it is not easy to request them, because the mesh is three-dimensional and the tooth thickness and the height of tooth become large from the toe through the heel, unlike a cylindrical gear.Therefore, in a previous report by using approximate equations of deflection-influenced functions and the bending moment-influenced functions of a tooth of a bevel gear, we proposed the method to calculate the load distribution on the contact line of a tooth of bevel gear and the tension-side root stress.In this report, we examined the influence of number of teeth and gear ratio for them.

• 一般社団法人日本機械学会の論文
• 1999-06-15

著者

• Sentoku Hirofumi

  Faculty Of Engineering Yamaguchi University

関連論文

• A Study on the Dynamic Behavior of a Skew Bevel Gear : 1st Report, On Root Stress Ratio, Torsional Vibration, Bending Vibration of Gear Shaft, and Vibrating Displacements in Three Right-Angled Directions : Series C : Vibration, Control Engineering, Engine
• Study on Tooth Bearing of Bevel Gears : 2nd Report, Relation between Tooth Bearing and Assembly Error, Shaft Angle Error
• Study on Tooth Bearing of Bevel Gears : 1st Report, Theoretical Calculation of Tooth Bearing and Experiment
• Load Distribution and Tooth Root Stress of Bevel Gears

スポンサーリンク