Method for Inspection of Spiral Bevel Gears in Klingelnberg Cyclo-Palloid System
スポンサーリンク
概要
- 論文の詳細を見る
In this paper, an inspection method for detecting machine setting errors such as tool setting and workpiece setting errors in spiral bevel gear cutting in a Klingelnberg cyclo-palloid system is proposed. In this method, the coordinates of many points on the gear tooth surface are measured and a theoretical gear tooth surface expressed as a function of the machine settings is estimated by the method of least squares so that the surface fits the measured data. The deviations of the estimated machine settings from the design settings are considered to be the machine setting errors. The machine setting errors in gear cutting were detected using this method and corrective cutting which compensated for the errors was carried out. As a result, more accurate gears could be obtained.
- 一般社団法人日本機械学会の論文
- 1996-03-15
著者
-
Nakano Yoshihiro
Hitachi Koki Co. Ltd
-
Nakano Yoshihiro
Matsushita Electric Works Ltd.
-
TAMURA Hisashi
Faculty of Engineering, Niigata University
-
KAWASAKI Kazumasa
Faculty of Engineering, Niigata University
-
Tamura Hisashi
Faculty Of Engineering Niigata University
-
Kawasaki K
Niigata Univ. Niigata Jpn
関連論文
- Finite Element Analysis of Thermal Behaviour in Metal Machining : 2nd Report, Determination of Energy Balance and Its Application to Three-Dimensional Analysis
- Finite Element Analysis of Thermal Behaviour in Metal Machining : 1st Report, Influence of Thermophysical Properties on Cutting Temperature
- Method for Inspection of Spiral Bevel Gears in Klingelnberg Cyclo-Palloid System
- A Study of the Gear Cutting Method of Spiral Bevel Gears with a Tapered Tooth Height : A Practical Method without Cutter Tilt : Series C : Vibration, Control Engineering, Engineering for Industry
- Simulation Analysis of Cutting Performance of Diamond in Titanium Machining
- A Study on the Method of Inspecting a Spiral Bevel Gear : Series C : Vibration, Control Engineering, Engineering for Industry