Hourglass Worm Gears Designed to Concentrate Surface Normals

スポンサーリンク

概要

• 論文の詳細を見る

• To avoid the influence of small displacement of gear axes under load, the authors propose that all contact normals of a tooth surface should be at right angles to the direction of the small displacement induced at each contact point under load. On the basis of this state of surface normals, a few methods of tooth surface generation have been devised for realizing the concept. In this research, an hourglass worm gear was made using one of the generating methods, and tested experimentally. As a result, the validity of this designing concept was substantiated.

• 一般社団法人日本機械学会の論文
• 1994-06-15

著者

• Kawada Hiroshi

  Mitsubishi Heavy Industrial Co. Ltd.

• SHIMACHI Shigeyuki

  Faculty of Engineering, Tohoku University

• GUNBARA Hiroshi

  Department of Mechanical Engineering, Matsue National Colledge of Technology

• Kobayashi Tohru

  Mitsubishi Heavy Industrial Co., Ltd.

• Shimachi Shigeyuki

  Faculty Of Engineering Iwate University

• Kobayashi Tohru

  Mitsubishi Heavy Industrial Co. Ltd.

• Gunbara Hiroshi

  Department Of Mechanical Engineering Matsue College Of Technology

関連論文

• A Method of NC Gear Cutting with Simply Shaped Tool : Application to Worm Wheel Cutting : Series C : Vibration, Control Engineering, Engineering for Industry
• A Simple Method of Bevel Gear Cutting : 2nd Report, Crowning Method
• A Simple Method of Bevel Gear Cutting : 1st Report, The Basic Conception of the Cutting Method
• A Study on NC Gear Cutting of Large-size Bevel Gears : 3rd Report; A Method to Save Path Number of the Cutter in Tooth Generation
• A Study on NC Gear Cutting of Large-size Bevel Gears : 2nd Report; End-milling for the Taper Tooth
• A Study on NC Gear Cutting of Large-size Bevel Gears : 1st Report: Cutting by End Milling
• GDS-16 STUDY ON MESHING OF GEAR TEETH(DESIGN AND SYNTHESIS OF A PAIR OF GEARS OR OF GEAR TRAINS)
• Hourglass Worm Gears Designed to Concentrate Surface Normals

スポンサーリンク