RELATIONS BETWEEN PROCESS OF CUTTING AND UNIQUENESS OF SOLUTIONS

スポンサーリンク

概要

• 論文の詳細を見る

• When an accurate stress analysis is to be made for excavation problems, it is desirable to make a step-by-step calculation by simulating the actual steps of excavation procedure. In this connection, there arise some fundamental questions as to whether the solutions are all identical when the order of cutting is changed, and whether the solution for multistage cutting equals that for a single-step cutting. To check the uniqueness of the solution for these different methods of cutting, the uniqueness proof was investigated by following the conventional method of approach which has been used extensively in the theory of elasticity and plasticity. The well-known theorem of virtual work was applied to the proof together with the stress-strain relationship of the material. It is shown that the uniqueness depends strongly upon the material properties, and that the sufficient condition for the uniqueness to be established is that the material is linear, time-independent and elastic throughout the cutting process.

• 社団法人地盤工学会の論文

著者

• Ishihara Kenji

  Civil Engineering Dep't. University Of Tokyo.

• Ishihara Kenji

  Civil Engineering Department Of Civil Engineering University Of Tokyo

関連論文

• THE GENERAL THEORY OF STRESSES AND DISPLACEMENTS IN TWO-LAYER VISCOELASTIC SYSTEMS
• DAMAGE TO ROADS, DIKES AND HIGHWAY BRIDGES DURING THE TOKACHIOKI EARTHQUAKE
• APPROXIMATE FORMS OF WAVE EQUATIONS FOR WATER-SATURATED POROUS MATERIALS AND RELATED DYNAMIC MODULUS
• RELATIONS BETWEEN PROCESS OF CUTTING AND UNIQUENESS OF SOLUTIONS
• VIBRATION BEHAVIOR OF A SAND LAYER RESTING UPON INCLINED FIRM UNDERGROUND BOUNDARIES

スポンサーリンク