Modeling the Imperfect Ground of Printed Circuit Boards Based on TEM Assumption
スポンサーリンク
概要
- 論文の詳細を見る
The radiation emission in far zones from printed circuit boards(PCBs) is obtained by treating lines on PCBs as transmission lines and calculating the far-field emission due to current distribution on lines. In this paper, we present a more precise circuit model, based on TEM assumption, to decompose the total current into differential-mode current and common-mode current. This circuit model is based on transmission line model, but it considers the effect of ground trace. The finite size ground trace can be viewed as an inductive reactance. A knowledge of the net inductance of the ground trace can aid in the analysis and investigation of PCBs emission. We show the derived equations of the modified transmission lines for the geometrics of partical interest. As time-varying current passes through such ground trace, a voltage drop due to the inductance of the trace will act as a source of the common-mode current. Furthermore, charge stored in capacitance between signal and ground traces will cause the current pulses returning to their source. The magnitudes of currents are slightly unequal in the signal and ground traces, which can cuase common-mode current to flow. An unbalanced circuit on a PCB constructed with signal and ground trace pairs will radiate as an asymmetric folded-dipole. By antenna theory, the contribution of differential-mode and common-mode currents to radiated emission of PCBs can be calculated. In addition, comparisons between experimental results and calculation results are also given.
- 社団法人電子情報通信学会の論文
- 2000-09-25
著者
-
Chen I‐f
Jin‐wen Inst. Of Technol. Twn
-
CHEN I-Fong
Department of Electronic Engineering, Jinwen University of Science and Technology
-
Luo Wen-yuh
Department Of Electronic Engineering National Taiwan University Of Science And Technology
-
Chen I-fong
Department Of Electronic Engineering Jin-wen Institute Of Technology:department Of Research Auden Te
-
HSUE Ching-Wen
Department of Electronic Engineering, National Taiwan University of Science and Technology
-
KUAN Ming-Chih
Department of Electronic Engineering, National Taiwan University of Science and Technology
-
Hsue Ching-wen
Department Of Electronic Engineering National Taiwan University Of Science And Technology
-
Kuan Ming-chih
Department Of Electronic Engineering National Taiwan University Of Science And Technology
-
Chen I-fong
Department Of Electrical Engineering Jinwen University Of Science And Technology
関連論文
- Printed Modified Bow-Tie Dipole Antenna for Multi-Band Applications
- Modeling the Imperfect Ground of Printed Circuit Boards Based on TEM Assumption
- Modified Tab Monopole for Thple-Band Cellular Phone Antenna
- A Dual Band Planar Inverted-F Antenna with Non-uniform Meander-Line Shaped Slot(Antenna and Propagation)
- Modified Printed Folded λ/2 Dipole Antenna for DVB Applications(Antennas and Propagation)
- Low Cost Printed Omni-Directional Spiral-Mode Monopole Antenna for Wireless Applications(Antenna and Propagation)
- Evaluation of Common-Mode Radiation from Printed Circuit Boards by Modelling Imperfect Ground Effect(Regular section)
- Compact Wide-Band Antenna for Dual ISM-Band Applications(Antenna and Propagation)
- Inverse Scattering of Nonuniform Transmission Lines by Using Arbitrary Waveform
- Planar Compact Inverted-F Antenna for Wireless Wide Area Network Operation in the Laptop Computer