Corrosion Behavior of Pure Titanium and Titanium Alloys in Fluoride-containing Solutions
スポンサーリンク
概要
- 論文の詳細を見る
The effects of fluoride concentrations and pH on the corrosion behavior of pure titanium, Ti-6Al-4V, Ti-6Al-7Nb alloys and a new Ti alloy adding palladium, which is expected to promote a repassivation of Ti were examined by anodic polarization and corrosion potential measurements. The amount of dissolved Ti was analyzed by inductively coupled plasma mass spectroscopy. The surface of the specimen was analyzed by X-ray photoelectron spectroscopy before and after the measurement. Pure Ti, Ti-6Al-4V and Ti-6Al-7Nb alloys were easily corroded even in a low fluoride concentration in an acidic environment. The corrosion resistance of Ti-0.2Pd alloy was greater than those of pure Ti, Ti-6Al-4V and Ti-6Al-7Nb alloys in the wide range of pH and fluoride concentrations. The high corrosion resistance of Ti-0.2Pd alloy was caused by the surface enrichment of Pd promoting a repassivation of Ti. The Ti-0.2Pd alloy is expected to be useful as a new Ti alloy with high corrosion resistance in dental use.
- 日本歯科理工学会の論文
著者
-
Nakagawa Masaharu
Section Of Biomaterials Engineering Division Of Oral Rehabilitation Faculty Of Dental Science Kyushu
-
Matsuya Shigeki
Section Of Bioengineering Department Of Dental Engineering Fukuoka Dental College
-
Matsuya Shigeki
Section Of Biomaterials Engineering Division Of Oral Rehabilitation Faculty Of Dental Science Kyushu
-
UDOH Koich
Section of Biomaterials Engineering, Division of Oral Rehabilitation, Faculty of Dental Science, Kyu
-
Udoh Koich
Section Of Biomaterials Engineering Division Of Oral Rehabilitation Faculty Of Dental Science Kyushu University
関連論文
- Effects of liquid phase on basic properties of α-tricalcium phosphate-based apatite cement
- Fabrication of carbonate apatite block based on internal dissolution-precipitation reaction of dicalcium phosphate and calcium carbonate
- Fabrication of B-type carbonate apatite blocks by the phosphorization of free-molding gypsum-calcite composite
- Fabrication of Si-substituted hydroxyapatite foam using calcium silicates( Ceramics for Biomedical Applications in Asian Countries)
- Effects of tricalcium silicate addition on basic properties of α-tricalcium phosphate cement( Ceramics for Biomedical Applications in Asian Countries)
- Fabrication of low-crystalline carbonate apatite foam bone replacement based on phase transformation of calcite foam
- Fabrication of low-crystalline carbonate apatite foam bone replacement based on phase transformation of calcite foam
- In vitro osteoconductivity evaluation of alumina treated hydrothermally in CaCl2 solution
- Corrosion Behavior of Pure Titanium and Titanium Alloys in Fluoride-containing Solutions
- Effects of Fluoride and Dissolved Oxygen Concentrations on the Corrosion Behavior of Pure Titanium and Titanium Alloys
- Hydrothermal calcium modification of 316L stainless steel and its apatite forming ability in simulated body fluid
- Preparation of Sr-containing carbonate apatite as a bone substitute and its properties
- Fabrication of solid and hollow carbonate apatite microspheres as bone substitutes using calcite microspheres as a precursor
- Assessment of Vickers hardness, microstructure, and surface roughness of dentin after initial dissolution by acidulated phosphate-fluoride
- Measurement of vaporization cavity after CO_2 laser irradiation on bovine dentin
- The effects of treated time of acidulated phosphate fluoride solutions on enamel erosion