Studies on the Unsteady Boundary Layer on a Flat Plate Subjected to Incident Wakes : Forced Transition Models of the Boundary Layer
スポンサーリンク
概要
- 論文の詳細を見る
Detailed studies are conducted to investigate the effects of the incident wakes generated by rotating circular cylinders on the characteristics of the transitional boundary layer developing on a flat plate. In this report, the primary concern is to measure the time-averaged heat transfer distribution along the flat plate under several conditions of wake characteristics and cylinder speeds. The obtained data are then utilized in the development of a simple but accurate model for an intermittency factor of the transitional boundary layer subjected to the incoming wakes. Two transition models, the Mayle-Dullenkopf model and a geometrical intermittency factor model, i. e. , a modified Pfeil model, are employed for comparison with the measured heat transfer data, and it is found that the latter model, which only considers evolution of the turbulent spot in the space-time domain, yields a better prediction.
- 一般社団法人日本機械学会の論文
- 1993-11-15
著者
-
Funazaki Ken-ichi
Department Of Mechanical Engineering Iwate University
-
YAMAWAKI Shigemichi
Ishikawajima-Harima Heavy Industries Co., Ltd.
-
Meguro Toshikatsu
Motoyama Engineering Works, Ltd.
-
Yamawaki Shigemichi
Ishikawajima - Harima Heavy Industries Ltd.
-
Meguro Toshikatsu
Motoyama Engineering Works Ltd.
関連論文
- Numerical Simulation of Bypass Transition by the Approach of Intermittency Transport Equation
- A210 Experimental and Numerical Studies on Leading Edge Film Cooling of a HP Turbine Blade Model(Gas Turbine-6)
- Numerical Analysis of Tip Leakage Flow Field in a Transonic Axial Compressor Rotor
- Experimental Studies on Wake-Induced Bypass Transition of Flat-Plate Boundary Layers under Favorable and Adverse Pressure Gradients
- Studies on Effects of Periodic Wake Passing upon a Blade Leading Edge Separation Bubble : Suppresion of Separation Bubble Due to Wake Passing
- TS-78 Heat Transfer Measurements of an Integrated Cooling Configuration Designed for Ultra-High Temperature Turbine Blades(Session C-9 Turbine Cooling 1)
- Numerical Simulation on the Flow Field in a Turbine Stage with Upstream Flow Injection from the Outer Casing : Effects of the Injection Angle
- Unsteady Aerodynamic Responses of Mistuned Cascades to Incoming Wakes : Mistuning of Stagger Angle
- Measurement of Surface Heat Transfer inside va Serpentine Passage by Use of Liquid Crystal
- Effects of Free-Stream Turbulence and Periodic Wake Passing on the Leading Edge Film Cooling of Turbine Blade (Heat Transfer and Heat Load Distributions)
- Studies on the Unsteady Boundary Layer on a Flat Plate Subjected to Incident Wakes : Forced Transition Models of the Boundary Layer
- Studies on Unsteady Layers on a Flat Plate Subjected to Incident Wakes and Free-Stream Turbulence