Absorption of Water Vapor into a Film of Aqueous Solution of LiBr Falling along a Vertical Pipe

スポンサーリンク

概要

• 論文の詳細を見る

• The heat transfer surface used in the experiments is a chrome-plated smooth brass pipe of 28mm diameter and 1400mm length. The film Reynolds numbers are varied in the range of 40-400, which includes the range of real machines. The average absorptions mass flux is compared with the numerical results derived from the laminar flow model proposed in the previous paper. The agreement is good up to 100 in Re_f, but the experimental values are far higher above 200. This may be attributed to the wave motions on the film surface. Pictures show that the film is completely smooth only at Re_f below 20. Beyond 20, ring-shaped waves appear, but the surfaces between the waves are relatively smooth at Re_f below 200. The measurements of the film thickness show that its minimum is constant at about 0. 38mm, but its maximum thickness increases for Re_f larger than 60.

• 1993-05-15

著者

• Morioka Itsuki

  Faculty Of Engineering Tokushima University

• Morioka Itsuki

  Faculty Of Engineering The University Of Tokushima

• Kiyota Masanori

  Faculty Of Engineering The University Of Tokushima

• Nakao Ryuuji

  Faculty of Engineering, Tokushima University

関連論文

• Absorption of Water Vapor into a Film of Aqueous Solution of LiBr Falling along a Vertical Pipe
• Absorption of Water Vapor into Lithium Bromide-water Solution Film Falling along a Vertical Plate
• The Fundamental Study on Chill Mould Casting Heat Transfer

スポンサーリンク