Combined Macroscopic and Microscopic Thermo-Elasto-Plastic Stresses of Functionally Graded Plate Considering Fabrication Process
スポンサーリンク
概要
- 論文の詳細を見る
Functionally Graded Material (FGM) is a heterogeneous composite material that consists of a gradient compositional variation of the constituent materials from one surface of the material to the other. These continuous changes result in gradient material properties. Since ceramic has good heat resistance and metal has high strength, FGM made by ceramic and metal can work at super high temperatures or under a high-temperature-difference field. It is a primary concern to reduce thermal stress by selection of different effective material properties for the intermediate composition of the FGM and to prevent destruction by thermal stress. FGM is manufactured at a high temperature and then residual thermal stresses are produced during cooling to room temperature. In this paper, the elastic-plastic thermal stresses induced in a ceramic-metal FGM plate (FGP) taking the fabrication process into consideration are discussed. The region near the heat resistant surface is produced by metal particle reinforced ceramic while the region near the cooling surface is vice versa. As the metal and the ceramic near the middle region of the FGM are perfectly mixed, it is impossible to consider the particle-reinforced material. In this study, the FGP is divided into three regions. First, the region near the cooling surface is metal rich and then the metal is considered as a matrix while the ceramic is considered as particles. Second, the region near the heat resistant surface is ceramic rich so that the ceramic is considered as a matrix while the metal is considered as particles. Third, in the middle part between the previous two regions the metal and ceramic are perfectly mixed. In the third region macroscopic analysis is considered because the difference between the volume fractions of the ceramic and the metal is small and it is difficult to consider one of them as a matrix or particles. The effects of the distribution parameter of the composition and the fabrication temperature on the thermal stress variations are discussed.
- 2001-07-15
著者
-
Tohgo Keiichiro
Mechanical Engineering Department Shizuoka University
-
Noda Naotake
Mechanical Engineering Department Shizuoka University
-
SHABANA Yasser
Graduate School of Science and Engineering, Shizuoka University
-
Shabana Yasser
Graduate School Of Science And Engineering Shizuoka University
関連論文
- Combined Macroscopic and Microscopic Thermo-Elasto-Plastic Stresses of Functionally Graded Plate Considering Fabrication Process
- An Inverse Problem of Coupled Thermal Stress in a Long Circular Cylinder
- 319 Transient Thermal Stresses in a Metal-Ceramics Mixture Plate Taking the Fabrication Process into Consideration