230 紙積層造形モデルを使用した鋳造鋳型の作製

概要

論文の詳細を見る
By using the paper laminating model produced with paper laminating rapid prototyping system as a master model for casting mold, the cost reduction at the time of producing a variety of products is tried. Although The direction draw out a model was restricted since the paper laminating model was weak for the load of the direction of laminating when the paper laminating model could be applied as CO_2 process or a pepset mold production or having been experimented, it turns out that a mold is producible. It turns out that it is difficult to burn a paper laminating model in heating by the gas burner, and it is difficult to use as a simple disappearance model. However, when performing heat-resistant processing to the paper laminating model, a possibility that it could be used as a mold was found out.
一般社団法人日本機械学会の論文
2002-08-29