618 Casting of wire-inserted composite strip using a downward melt-drag twin roll caster

スポンサーリンク

概要

• 論文の詳細を見る

• A wire-inserted composite strip was cast using a downward melt-drag twin roll caster. The downward melt-drag twin roll caster was easily modified to a twin roll caster for the composite strip by simply attaching a coil of wire. Wire of either 0.3-mm and 0.6-mm diameter could be inserted continuously both inside and at the surface of the strip. The insertion of wire did not affect the castability of the strip. At a suitable roll speed, no void formed between the wire and the strip. The wire-inserted strip could be rolled without defect between the wire and the strip. Draft of the wire diameter was almost same as that of the strip after rolling. The wire and the strip reacted at the some condition. However, the reacting layer was very thin.

• 一般社団法人日本機械学会の論文

著者

• Takahashi Kenta

  Osaka Institute Of Technology

• HAGA Toshio

  Department of Mechanical Engineering, Osaka Institute of Technology

• Haga Toshio

  Department Of Mechanical Engineering Osaka Institute Of Technology

関連論文

• High-Speed Twin-Roll Strip Casting of Al-Mg-Si Alloys with High Iron Content
• Refined Solidification Structure and Improved Formability of A356 Aluminum Alloy Plate Produced using a High-Speed Twin-Roll Strip Caster
• High-Speed Twin Roll Casting of Thin Aluminum Alloy Strips Containing Fe Impurities
• 618 Casting of wire-inserted composite strip using a downward melt-drag twin roll caster
• 617 Thixoforming of laminate assembled from roll cast strips
• Characteristics of Electrolytic Copper Powder Compaction by Differential Speed Rolling

スポンサーリンク