331 Dynamic cutting force and temperature in milling of hard-to-machine material using small end mill : Milling of 29Ni-17Co alloy

スポンサーリンク

概要

• 論文の詳細を見る

• This paper presents the dynamic cutting force and cutting temperature during cutting 29Ni-17Co alloy using φ1-3mm end mills rotating at a spindle speed of 10,000-40,000/min. A dynamic cutting a force in the frequency range of more than 10kHz, and a cutting temperature at a sampling rate of less than 30 μs, were detected. Tool wear is explained in view of the dynamic cutting force and the cutting temperature. As a result, and increase in cutting speed and feed per tooth in milling conditions is significantly effective in minimizing tool wear.

• 一般社団法人日本機械学会の論文

著者

• Masuda Masami

  Niigata University

• TANAKA Masato

  Niigata University

• TAKAHASHI Yuhki

  Murata Manufacturing Co.

• YAZAWA Takanori

  Niigata University

関連論文

• 331 Dynamic cutting force and temperature in milling of hard-to-machine material using small end mill : Milling of 29Ni-17Co alloy
• Microdrilling for printed circuit boards (PCBs)-Influence of radial run-out of microdrills on hole quality

スポンサーリンク