B308 SOOT PARTICLE REENTRAINMENT IN A CORONA DISCHARGE REACTOR(Turbulent flame-2)
スポンサーリンク
概要
- 論文の詳細を見る
Among the various types of diesel after-treatment device, the corona discharge reactor may be considered as a powerful tool for trapping submicron particles. But after precipitation on the electrodes occurs, the reentrainment of particles is severe and often causes low or negative precipitation efficiency. Experiments were performed to investigate the effect of an applied voltage on the reentrainment of soot particles from the electrodes. A co-annular laminar diffusion flame burner was used as the soot generator. When a highly negative voltage was applied, exfoliation of the deposited soot particles and an increase in concentration of particles smaller than approximately 150 nm were observed. Turbulence induced from the negative tuft corona and sputtering caused particle reentrainment from the corona wire and from plates as well. Under soot laden combustion gas, a streamer corona often occurred in the wire-cylinder reactor. Because of its transient nature, streamer corona violently increased the concentration of reentrained particles and CO gas.
- 一般社団法人日本機械学会の論文
- 2000-10-01
著者
-
Hwang J‐h
Dept. Of Mechanical Eng. Yonsei Univ.
-
Lee Jae-bok
Dept. Of Mechanical Eng. Yonsei Univ.
-
Hwang Jung-ho
Dept. Of Mechanical Eng. Yonsei Univ.
-
BAE Gwi-Nam
Global Environment Research Center, KIST, P. O.
-
Bae Gwi-nam
Global Environment Research Center Kist
関連論文
- Soot Particle Re-entrainment in a Corona Discharge Reactor
- B308 SOOT PARTICLE REENTRAINMENT IN A CORONA DISCHARGE REACTOR(Turbulent flame-2)