GDS-6 GEOMERICAL DESIGN OF FACE-GEAR DRIVES FOR POWER TRANSMISSION(GEAR DESIGN AND SYNTHESIS)

スポンサーリンク

概要

• 論文の詳細を見る

• Because of the geometrical limitation of face tooth width, the face-gear drives were applied usually only for low power or motion transmission. In order to extend the application, tooth width design is thus a very important topic for the design of face-gear drive. In this presentation, the authors show a new concept to design the face-gear drive for power transmission by applying nonstandard basic rack and profile shifting. Additionally, an optimal relation of helix angle and offset will be established to get a maximum face width and better mesh performance for hypoid face gear. A new classification and method to calculating the contact ratio of face gear drive are also introduced. Finally, a numerical example will illustrate the mentioned concepts and calculation methods.

• 一般社団法人日本機械学会の論文
• 2001-11-15

著者

• Roth Karlheinz

  Institute For Engineering Design Machine- And Precision Element Technical University Of Brunswick

• Tsai Shyi-jeng

  Department Of Mechanical Engineering National Central University

• TSAI Shyi-Jeng

  Department of Mechanical Engineering, National Central University

関連論文

• GDS-12 DESIGNING SKEW CONICAL GEAR DRIVES IN APPROXIMATE LINE CONTACT FOR POWER TRANSMISSION(DESIGN AND SYNTHESIS OF A PAIR OF GEARS OR OF GEAR TRAINS)
• GDS-6 GEOMERICAL DESIGN OF FACE-GEAR DRIVES FOR POWER TRANSMISSION(GEAR DESIGN AND SYNTHESIS)

スポンサーリンク